DIAMOND DRYERS HD-D380S Gebruiksaanwijzing en onderdelenhandleiding - Pagina 4

Blader online of download pdf Gebruiksaanwijzing en onderdelenhandleiding voor {categorie_naam} DIAMOND DRYERS HD-D380S. DIAMOND DRYERS HD-D380S 6 pagina's. Surface mounted high speed hand dryer

Pagina afdrukken
CAUTION: Before installation decide if the cable entry is to be from the rear
or the above. Follow the relevant instructions. Do not use the backplate as a
guide when drilling.
Service Tool
Service Tool
2. POSITIONING
2.1 Mark the location on the wall with a
pencil. Use the Backplate to mark the
locations for the four fixing points (
2.2. Pre-drill the wall in the marked
locations using a 5/16 (8mm) drill, inset
the plastic anchors and tap flush to the
High-Speed Hand Dryer
Installation Manual
wall (
).
3
2.3 Fix the backplate to the wall. Screw to
the wall and secure with the appropriate
fitting.
Manual
3. INSTALLING THE POWER
CABLE & CONNECTION
TERMINAL BLOCK
WARNING: ENSURE POWER IS NOT
CONNECTED
3.1 Pull the cable through the grommet.
Ensure the cable is long enough to route
correctly through the backplate to the
terminal block.
3.2 The cable must sit in the dedicated
channel.
Above
cable entry
3.3 As shown, connect cable to terminal
block (
).
4
Above
Grommet
cable entry
3.4 Screw in terminal block.
3.5 Fix the cable clamp with screw in the
backplate.
CAUTION: Connect the ground wire to
the terminal block marked '
Do not over-tighten and crush the
power cable.
4. ATTACHING MAIN BODY
4.1 Close the main cover of the backplate
(
).
5
4.2 Insert and tighten the (2) security
screws into the side of the main body
with the service tool as illustrated below.
4.3 Turn power on.
4.4 Test unit for correct operation.
Main Unit
Main Unit
Wall Mouting
anchors
Flat cable clamp
& Screw
Grommet
L
N
L
N
'.
Recommended height measurements
from the floor to top screws (
Adult male
).
2
Adult female
Service Tool
Children 5-8 years old
Service Tool
Children 8-11 years old
Children 11-14 years old
Wheelchair user
1
2
3
Above
cable entry
6mm
6mm
4
Above
Above
Grommet
cable entry
cable entry
5
Manual
Manual
Main Unit
Main Unit
Grommet
L
N
Grommet
L
L
N
N
Flat cable clamp
Flat cable clamp
& Screw
& Screw
).
1
1300mm
1265mm
928mm
1028mm
1108mm
1050mm
6mm
6mm
6mm