Panasonic AU-V35C1 Procedures voor firmware-updates - Pagina 4

Blader online of download pdf Procedures voor firmware-updates voor {categorie_naam} Panasonic AU-V35C1. Panasonic AU-V35C1 5 pagina's.

Never fail to perform this after the update

After AU-V35C1 is updated, please perform ABB with the lens cap fitted on

according to the procedure. This is for the sensor adjustment needed after

120p mode is newly equipped.

Only the first ABB adjustment after the update is definitive. It cannot be

done over again.

Please be careful because, if it is not successfully completed, the product

will not work correctly when you use it.

MENU ： SYSTEM SETTINGS > SYSTEM MODE

FREQUENCY

PIXCEL

MAIN CODEC

HIGH SPEED

Reboot the camera and wait for 15 minutes or longer with the power on.

Check SENSOR TEMP and, if it is not between 38℃ and 43℃, wait for a further 15 minutes or so.

MENU: SYSTEM SETTINGS > INFORMATION > SENSOR TEMP

(Temperature readings can be updated by pushing the jog dial button two times.)

Be sure to put the lens cap or mount cap to block out the light completely.

(If you proceed to the next step without blocking the light, you cannot perform

ABB again by MENU even after it is not completed.)

MENU: SYSTEM SETTINGS > COLOR SETTING

MAIN

V-709

MENU: CAMERA SETTINGS > Enhanced > Enhanced SW > ON

MENU: CAMERA SETTINGS > BLACK > ABB

[EXECUTE]

After about a minute, "ABB ACTIVE" is displayed on the panel.

When "ABB OK" is displayed, ABB is completed.

However software cannot be updated, please contact Panasonic Service Engineering.

59.94p

4096 x 2160

AVC-Intra4K-LT

ON (60-120fps)

Page4/5

Firmware update procedure for Varicam series

between 38℃ and 43℃

January 2015