HP 1810-24G Handleiding voor snelle installatie - Pagina 2
Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} HP 1810-24G. HP 1810-24G 4 pagina's. 1810 series
Ook voor HP 1810-24G: Quickspecs (25 pagina's)
Pagina afdrukken
4.
Mount the switch (continued)
Wall or Under-Table Mounting: Install two 5/8-inch (15.875 mm)
number 12 wood screws, (included) into the mounting surface,
positioned 10 inches (254 mm) apart. Use the wall anchors if
necessary. Then, position the switch over the screws and slide to
lock in place. Install the third screw at the side of the switch to
prevent it from sliding out of the locked position, if necessary.
Important: For wall-mounting, the network ports must be facing
up or down. Do not mount the switch with ventilation holes facing
up or down. (See "Installation Precautions" on page 4.)
5
. Power on the switch.
Follow the same procedures as in step 3.
6.
Configure the switch for operation on your network
(minimal configuration).
Using a standard Ethernet cable, connect a PC directly to the
switch.
Then configure the PC's IP Address and Subnet Mask to allow it to
communicate with the switch through your PC's Web browser.
Switch factory-default settings:
Parameter
Factory Default Setting
Password
<blank>
IP address
192.168.2.10
Subnet mask
255.255.255.0
Default gateway
not set
Modify the switch's IP configuration to operate in your network.
See the example initial configuration on page 3.
7
. Connect the network cables.
Note: For transceiver connections, install and use only
HP mini-GBIC/SFP transceivers supported by the switch.
See "Mini-GBIC/SFP Installation Notes" on page 3.
2
5/8-inch #12
screws
Connect to
any port