HP 316095-B21 - StorageWorks Edge Switch 2/24 Handleiding voor installatie-instructies - Pagina 15

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} HP 316095-B21 - StorageWorks Edge Switch 2/24. HP 316095-B21 - StorageWorks Edge Switch 2/24 16 pagina's. Edge switch release notes
Ook voor HP 316095-B21 - StorageWorks Edge Switch 2/24: Handleiding bijwerken (9 pagina's), Handmatig (41 pagina's), Handmatig (40 pagina's), Release Release (32 pagina's), Release Release (27 pagina's), Handmatig (26 pagina's), Release Release (27 pagina's), Release Release (25 pagina's), Handleiding voor installatie-instructies (24 pagina's), Release Release (23 pagina's), Release Release (23 pagina's), Release Release (22 pagina's), Release Release (23 pagina's), Release Release (19 pagina's), Release Release (19 pagina's), Release Release (18 pagina's), Gebruiksaanwijzing (17 pagina's), Release Release (17 pagina's), Upgrade-instructies (16 pagina's), Gebruiksaanwijzing (16 pagina's), Release Release (16 pagina's), Release Release (17 pagina's), Release Release (17 pagina's), Release Release (11 pagina's)

Installing the Switch in the Cabinet

Use these steps to install the switch in the cabinet. You will need a #2 Phillips

screwdriver and two rear spacing brackets to complete this procedure.

1. From the front side of the cabinet, slide the switch into the mounting brackets and

along the rails until the rear of the switch is flush with the rear of the cabinet.

2. Bring the rear spacing brackets to the rear of the cabinet.

3. Pull the switch toward the rear of the cabinet until it protrudes approximately 3

inches.

4. Orient the rear spacing bracket mounts so that they are pointed outward. Insert the

tabs on each rear spacing bracket into the designated slots in each rail.

5. Push the switch forward using both rear spacing brackets until the rear spacing

bracket mounts contact the cabinet rail.

6. Attach the rear spacing brackets to the cabinet using two Phillips panhead screws

(10-32 x 5/8) with flat washer.

7. Ensuring that the square alignment washers are seated properly within the square

cabinet frame holes, use a Phillips head screwdriver to tighten the rear and front

mounting screws.

edge switch 2/24 rack mount kit installation instructions

Installation Instructions