AQUATECH EVO III Gebruiksaanwijzing - Pagina 6
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} AQUATECH EVO III. AQUATECH EVO III 8 pagina's. Sport housing
Ook voor AQUATECH EVO III: Gebruiksaanwijzing (5 pagina's)
Pagina afdrukken
to focus/fire or start/stop video.
What the Grease is used for:
The main purpose for the grease provided is to keep
the controls and shafts on your Sport Housing working
nice and smooth
Zoom Gear Control
Located on the front left of our Sport Housing, this
control drive gear engages our zoom gear to change
the focal length of the lens, where applicable.
Lens Port
Before installing your Lens Port make sure the Front O
Ring is present. Then place your port inside the front
Sport Housing and turn clockwise until its secure.
Remember to seal your Lens Port very tight with
both hands to ensure a good seal on the front O-ring
between your Lens Port and Sport Housing.
Securing the Housing
When you first receive your gear we recommend that
you do these steps without the camera and lens inside
the Sport Housing
Water Testing
Water testing is a very important process before
entering the water in all types of conditions. Once you
have followed "Securing The Housing" instructions we
recommend that you perform a water test yourself
without the camera and lens inside.
1. Fill up a bathtub, use a swimming pool or hop in the
ocean to test.
The choice is yours just as long as you have a body of
water where you can fully submerge your equipment.
2. Hold your equipment under the water for 5-10
seconds while also pressing all the buttons. Then hold
the Sport Housing above your head at a tilted angle
so that if there is any water inside it will gather at the
bottom right back corner.
Cleaning and Storage
•
With your EVO lll Sport Housing assembled wash it
off with fresh water. *Do not get the inside wet.
•
Dry off the EVO lll Sport Housing with a clean towel
and unlock the clips. If you have access to an air gun
gently blow underneath the clips. If you do not have
access to an air gun you can use water pressure to
flush out the area. Just make sure not to get any
water inside the Sport Housing.
•
While holding the EVO lll Sport Housing under fresh
water push all the buttons and turn all the shafts.
•
While holding the EVO lll Sport Housing under fresh
water push and turn the AF-Shutter buttons.
•
If you are using a M3 Pistol make sure to remove it
after each use to clean away any debris or salt water.
DO
•
Clean the outside of your Sport Housing with fresh
water after each use.
•
Wipe away any debris that may have gathered on
the threads, buttons, or O-ring grooves.
5