3Com 10BASE-2 (BNC Installatiehandleiding - Pagina 3
Blader online of download pdf Installatiehandleiding voor {categorie_naam} 3Com 10BASE-2 (BNC. 3Com 10BASE-2 (BNC 6 pagina's. Unterminated ethernet 10base-2 (bnc) module
Pagina afdrukkenTo remove the faceplate:
1
Loosen the two captive screws securing the faceplate to the chassis.
2
Pull the faceplate away from the system.
LANplex 2500
R
You can replace a module while the system is powered on. Replacing the
Read if replacing
a module
module requires that you remove the attached cables from the module's
ports prior to installing the new module.
To replace a module:
1
Disconnect the cables from the module's ports.
2
Loosen the two captive screws securing the module to the chassis.
3
Pull the module out of the chassis.
The following figures show termination of unterminated BNC ports using
either a Y connector or a Feed-thru terminator.
R
LANplex 2500
ERROR
PCMCIA
Power
Run
Processor Power
Fan
Temp
Config
Captive screw
ERROR
PCMCIA
Power
Run
Processor Power
Fan
Temp
Config
Green = Active
Port Status
Yellow = Error
Board
Error
Unterminated
Board
Error
1
Y terminator
BNC terminating plug
Inserted
Faceplate
Inserted
Active
Error
1
2
3
4
5
6
7
8
Port Status
Active
Error
2
3
4
5
6
7
8
Unterminated
10BASE-2 (BNC)
option module
Captive screw
Captive screw