HP StorageWorks 1000 - Modular Smart Array Installatiehandleiding - Pagina 12

Blader online of download pdf Installatiehandleiding voor {categorie_naam} HP StorageWorks 1000 - Modular Smart Array. HP StorageWorks 1000 - Modular Smart Array 18 pagina's. Power supply, computer
Ook voor HP StorageWorks 1000 - Modular Smart Array: Netwerkhandleiding (8 pagina's), Ondersteuningslijst (34 pagina's), Handleiding voor foutpreventie (12 pagina's), Technisch witboek (12 pagina's), Firmware bijwerken (9 pagina's), Overzicht (20 pagina's), Installatiehandleiding (2 pagina's), Telefoonnummers voor ondersteuning (19 pagina's), Referentiehandleiding (48 pagina's), Administratiehandleiding (40 pagina's), Release Release (13 pagina's), Snel aan de slag Instructies (8 pagina's), Snelstarthandleiding (7 pagina's), Release Release (5 pagina's), Instructies voor vervanging (4 pagina's), Witboek (13 pagina's), Beknopte technologie (15 pagina's), Quickspecs (17 pagina's), Specificatie (49 pagina's), Aan de slag handleiding (34 pagina's), Installatie (4 pagina's), Handleiding demontage-instructies (9 pagina's), Handleiding voor programmering (8 pagina's)

1.3

Unpack Rackmount Box

The rackmount box is one of three long boxes found in the unit's shipping carton (see

Figure 1-1 ). It contains these instructions, two rack brackets, screws, two front brackets for

securing the unit in the rack, template, and a power cord bracket.

1.4

Decide the relative position of the AlphaServer DS15 in the rack. Base zero is where the

bottom of the unit will be when installed in the rack.

Base zero should be the horizontal centerline between the two square openings that are

closest to each other on the vertical rack rail.

If you are adding your AlphaServer DS15 to a rack already populated with other units, then

base zero is near the top of the unit that will be underneath the AlphaServer DS15 you are

installing. Each AlphaServer DS15 needs a clearance of 9 holes (square openings on the

vertical rack rail) to accommodate the three U height.

NOTE: One U of space must be left on the bottom of the rack for a PDU. All population

of rack systems must begin above this one U area."

1-2 Series 10000 Rackmount Installation

MR0274A