HP StorageWorks 8/8 - SAN Switch Release Release - Pagina 29

Blader online of download pdf Release Release voor {categorie_naam} HP StorageWorks 8/8 - SAN Switch. HP StorageWorks 8/8 - SAN Switch 43 pagina's. Hp storageworks fabric os 6.1.2b release notes (5697-0351, march 2010)
Ook voor HP StorageWorks 8/8 - SAN Switch: Release Release (30 pagina's), Release Release (29 pagina's), Release Release (32 pagina's)

Pagina afdrukken

HP StorageWorks 8/8 - SAN Switch Release Release

For any containers hosted on the failed GL node, issue cryptocfg --replace to

change the WWN association of containers from the failed GL node to the new GL node.

Replace the failed GL node with a new node:

On the new node, follow the switch/node initialization steps.

Create an Encryption Group on this fresh switch/node with the same Encryption Group

name as before.

Perform a configdownload to the new GL node of a previously uploaded configuration

file for the EG from an old GL Node.

For any containers hosted on the failed GL node, issue cryptocfg --replace to

change the WWN association of containers from failed GL node to the new GL node.

Initial setup of encrypted LUNs

IMPORTANT:

While performing first-time encryption to a LUN with more than one initiator active at the time, re-key

operations slow to a standstill. Define LUNs for a single initiator at a time to avoid this occurrence.

Fabric OS 6.2.0 fixes

The following table lists defects closed in the Fabric OS 6.2.0 firmware release.

Table 8 Fabric OS 6.2.0 closed defects

Closed defect summary

Add Member button is disabled while creating a new TI Zone when

the switch is in VF mode.

Under stress testing, cfgsave takes a long time and fails to propagate

on 64 VE-VE FCIP tunnel 33 switch core-edge topology running I/O.

Adding a B-Series switch with conflicting domain ID into an EOS fabric

may cause another switch to segment.

USB port LED of HP StorageWorks DC SAN Backbone Director CP

blade stays ON after HA failover.

CUP Port stuck in Contingent Allegiance State after z9 Host IPL.

Spinfab and porttest (diagnostics) are not supported on ICL ports.

Solution

Fixed in Fabric OS 6.2.0.

Workaround prior to upgrade:

Add Other Port button can be used to

add ports.Tthis is available in the

ADD TI Zone window.

Fixed in Fabric OS 6.2.0.

Workaround prior to upgrade:

Wait until fabric is not saturated to

push configs around.

Fixed in Fabric OS 6.2.0.

Workaround prior to upgrade:

Check the domain ID before adding

a switch to any fabric.

Fixed in Fabric OS 6.2.0.

HP StorageWorks Fabric OS 6.2.0b release notes