HP StorageWorks 8B - FC Entry Switch Handmatig - Pagina 17

Blader online of download pdf Handmatig voor {categorie_naam} HP StorageWorks 8B - FC Entry Switch. HP StorageWorks 8B - FC Entry Switch 50 pagina's. Fabric os release notes version 3.0.1b
Ook voor HP StorageWorks 8B - FC Entry Switch: Handleiding bijwerken (9 pagina's), Handleiding voor installatie-instructies (20 pagina's), Gebruikershandleiding (22 pagina's), Opmerkingen over firmware-uitgave (14 pagina's), Installatiehandleiding (14 pagina's), Release Release (26 pagina's), Gebruikershandleiding (44 pagina's), Gebruikershandleiding (44 pagina's), Gebruikershandleiding (38 pagina's), Gebruikershandleiding (38 pagina's), Gebruikershandleiding (37 pagina's), Gebruikershandleiding (30 pagina's), Release Release (16 pagina's)

Pagina afdrukken
HP StorageWorks 8B - FC Entry Switch Handmatig

Backing Up the System Configuration Settings

The two supplied utilities RSHD.EXE and CAT.EXE, currently do not support uploads for
Windows, only downloads. Therefore, FTP must be used on Windows workstations to backup the
system configuration, and the FTP server must be running before an upload can occur.
To upload a backup copy of the configuration settings to a host computer:
1.
Verify that the RSHD service (on a UNIX machine) or the FTP service (on a Windows
machine) is running on the host workstation.
2.
Login to the switch as the admin user.
3.
At the command line enter the following command:
configUpload "hostIPaddr", "user", "path_filename","password"
where hostIPaddr is the IP address of the host computer, user is the User ID used to log
into this computer, path_filename is the path location and filename of the configuration
file, and password is the password for the user ID specified.

Restoring the System Configuration Settings

To restore the system configuration settings from a backup:
1.
Verify that the RSHD service (on a UNIX machine) or the FTP service (on a Windows
machine) is running on the host workstation.
2.
Login to the switch as the admin user.
3.
Shut down the switch by entering the following command:
switchDisable
4.
At the command line enter the following command:
configDownload "hostIPaddr", "user", "path_filename","password"
where hostIPaddr is the IP address of the host computer, user is the User ID used to log
into this computer, path_filename is the path location and filename of the system
configuration file, and password is the password for the user ID specified.
Note:
5.
Reboot the switch by entering the following command:
fastBoot
Fabric OS Procedures Guide
The password operand is only required if you are using FTP.
Basic Configuration Procedures
2
2-3