HP XP20000/XP24000 Configuratiehandleiding - Pagina 12

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} HP XP20000/XP24000. HP XP20000/XP24000 30 pagina's. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Ook voor HP XP20000/XP24000: Release Release (13 pagina's), Integratiehandboek (29 pagina's), Release Release (4 pagina's), Handleiding voor beheerders (50 pagina's), Configuratiehandleiding (42 pagina's), Configuratiehandleiding (40 pagina's), Configuratiehandleiding (40 pagina's), Configuratiehandleiding (36 pagina's), Configuratiehandleiding (36 pagina's), Configuratiehandleiding (30 pagina's), Configuratiehandleiding (36 pagina's), Release Release (5 pagina's), Configuratiehandleiding (46 pagina's), Configuratiehandleiding (46 pagina's), Referentiehandleiding (46 pagina's), Configuratiehandleiding (40 pagina's), Configuratiehandleiding (44 pagina's), Configuratiehandleiding (38 pagina's), Configuratiehandleiding (34 pagina's), Configuratiehandleiding (30 pagina's)

Setting the system option modes

The HP service representative sets the system option mode(s) based on the operating system and

software configuration of the host. Notify your HP representative if you install storage agnostic software

(such as backup or cluster software) that may require specific settings.

Configure the disk array Fibre Channel ports by using P9000 or XP Command View Advanced Edition

Software or XP Remote Web Console (shown). Select the settings for each port based on your storage

area network topology. Use switch zoning if you connect different types of hosts to the array through

the same switch.

In fabric environments, the port addresses are assigned automatically. In arbitrated loop environments,

set the port addresses by selecting a unique arbitrated loop physical address (AL-PA) or loop ID for

each port. For specific values, see the HP StorageWorks XP24000/XP20000 LUN Manager User

Guide applicable to your array.

Set each array port to FABRIC ON or OFF with connections of POINT-TO-POINT or FC-AL as shown

in the following table and figures. For detailed topology information, see the HP StorageWorks SAN

Design Reference Guide at:

http://www.hp.com/go/sandesign.

Installing and configuring VMware for the XP family of disk arrays