Diamond Products CC1600 Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Diamond Products CC1600. Diamond Products CC1600 16 pagina's. Wall saw

To adjust the rollers: loosen the set screw, rotate the roller assembly with a 1-1/2"

wrench until the roller is in contact with the track, then tighten the set screw. If the

rollers are too loose, the saw will not cut smoothly and may jam the blade. If a roller is

adjusted too tight, it will be difficult to pull out when removing the saw.

To adjust the slides: loosen the set screw, turn the adjusting shaft with a 1/2" wrench

until the slide is in contact with the track, then tighten the set screw.

Connect the hydraulic lines to the blade drive motor and travel motors (if used)

and the water line to the blade guard support.

Run the saw along the track and rotate the arm through a complete circle before

mounting the blade to be sure the setup is correct.

Check the hydraulic and water lines while doing this to be sure they will not

interfere with travel or be cut by the blade.

Before mounting the blade, be sure the blade shaft turns clockwise (looking

toward the saw at the blade). Incorrect blade rotation will cause increased wear,

damage the blade, and may blow out motor seals.

Select the correct blade, based on the depth to cut and the stage of cutting. (See

Table 2) Walls over 15" thick will need more than one blade, a starting blade up to

∅ 36" to start the cut and one or more larger blades to complete the cut.

10.

Check blade speed, either with a shaft tachometer or by checking the hydraulic

fluid GPM rate and comparing it to Table 1 on page 6. Do not exceed the rated

blade speed.

11.

The CC1600 wall saw can take a blade of ∅ 36" or less out of the cut. To use a

larger blade, you must first make a cut with a ∅ 36" or smaller blade.

MOUNTING A STANDARD BLADE

Be sure you have the correct diamond wall saw blade. Using a blade not

manufactured for wall saw use could result in serious bodily injury.

Inspect the flanges and clean or replace if necessary. Inspect the blade for damage

to the arbor hole before mounting the blade.

Place the blade over the arbor on the inner flange. Be sure the blade is mounted

correctly. The "tails" behind the diamonds should point opposite the blade

rotation. Reversing the blade will cause higher blade wear.

Place the outer flange over the arbor, making sure the waterways are clear.

Tighten the flange nut to lock the blade in place. (NOTE: This is a left-hand nut.)

Never try to connect or disconnect the hoses while the

power unit is running and/or the hoses are under

WARNING!

pressure.