Diamond Products DP80900 Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Diamond Products DP80900. Diamond Products DP80900 12 pagina's. Wide area vacuum
Pagina afdrukken
VACUUM BAG INSTALLATION &
REMOVAL
1) Unlock rear door latch, and allow
door to hinge open.
2) Place paper bag / filter into tank
opening.
3) On paper bag / filter, slide rubber
vacuum collar onto vacuum intake
spout.
4) Close rear door and lock into place.
NOTE: Be sure the bag / filter is
properly placed in bag housing to
ensure proper air flow.
5) To remove bag, simply reverse steps
1-4 above.
6) Do not re-use paper bag / filter.
When full, dispose of it and replace
with a new one.
MACHINE MAINTENANCE
To keep the machine performing well
for many years, please follow the
following maintenance procedures.
!!! Always confirm that the
machine is unplugged prior to
performing any maintenance or
repairs!!!
1) Unplug machine as soon as you are
done using it.
NOTE: When unplugging machine, do
not pull cord around sharp edges or
corners & do not unplug by pulling on
the cord.
2) Clean outside of machine with a mild
cleaner.
3) Check power cord for any damage. If
any damage is detected, replace the
cord immediately.
4) Check machine for any loose or
missing nuts and bolts and replace as
necessary.
-6-
5) Check paper bag / filter for fullness.
If it is full, replace with a new one.
6) Check vacuum motor filter and
exhaust filter for debris and clean as
needed.
NOTE: Do not clean filters with water
or a cleaning solution. Clean by tapping
of debris or blowing with air.
7) Inspect brush for strands of carpet
and debris and remove as needed.
8) Inspect brush bristles for wear and
damage. Replace brush as needed.
9) Inspect gaskets and seals for air leaks
and replace as needed.
10) Check vacuum hose for clogs and
holes and replace as needed.
11) Check vacuum motor carbon brushes
every 250 hours. Replace brushes
when they are 3/8" or less in length.
NOTE: Vacuum motor damage
caused by worn brushes is not
covered by warranty.
MACHINE STORAGE
1) Prior to storing the machine, wrap up
power cord, check paper bag / filter
for fullness and replace if necessary.
2) Clean and / or replace filters.
3) Store machine in upright position in a
dry area, with the brush head off the
floor.
Diamond Products
Operator's Manual