Diamond Products TYRANT Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Diamond Products TYRANT. Diamond Products TYRANT 14 pagina's. Tyrant wet/dry vacuum

Pagina afdrukken
Operation of Tyrant Wet/Dry Vacuum
* Read operators manual thoroughly prior to
operating or servicing this machine.

WET PICKUP

1] Remove vacuum head and remove the
cloth or paper filter from vacuum, install the
bubble buster.
2] While vacuum head is removed, check to
make sure that the float shut-off is
unobstructed and fully functional.
3] Replace vacuum head and latch it in place.
4] Connect vacuum hose to inlet on the
machine body.
5] Attach appropriate accessory tool for the
job to be completed.
6] Plug power cord into a grounded outlet.
* Do not use an extension cord in conjunction
with the standard power cord.
7] If using the front-mounted squeegee
assembly, be
sure
attached to front of machine.
8] If using the front-mounted squeegee
assembly, lower squeegee to the floor by
depressing the top half of the pedal [rear of
the machine] forward with your foot.
9] Turn power switch to
10] During wet pickup, the float shut-off will
automatically prevent water from entering
the recovery tank once the recovery tank is
full.
* If foam develops in the recovery tank during
wet vacuuming, use de-foamer chemical to
help eliminate the foam. Foam will not activate
the float shut-off, and therefore, may cause
vacuum motor damage.
11] To raise the squeegee assembly back to
transport position, depress the bottom half of
the pedal [rear of the machine] downward
with your foot.
* Be sure that the handle is properly assembled
on machine body prior to operating
-5-
that squeegee
on
position.
"
"
machine.
* The Tyrant wet/dry vacuum includes the
"bubble buster" blue nylon foam suppression
bag. This bag must be used in all wet pick-up
applications. Failure to use the bag will void
the warranty on the vacuum motor.
1] Remove vacuum head and bubble buster,
and be sure the cloth or paper filter is
properly installed.
* Do not operate machine without bag or
filter properly installed.
2] Replace vacuum head and latch it in place.
3] Connect vacuum hose to inlet on the
machine body.
4] Attach appropriate accessory tool for the
job to be completed.
5] Plug power cord into a grounded outlet.
is
* Do not use an extension cord in conjunction
with the standard power cord.
6] Turn power switch to
7] Check the filter bag periodically to see if it
is full. For optimal performance, replace
bag when it is 3/4 full.

DRAINING THE RECOVERY TANK

1] Unplug machine from power outlet.
2] Transport machine to nearest floor drain or
bucket.
3] Remove drain hose from rear of machine.
Remove ball plug from drain hose, and
drain the contents of the tank.
4] After the contents have drained, remove
the vacuum head and rinse recovery tank
with clean water.
5] Replace the ball plug on the drain hose and
hang hose back on the rear of the machine.
 To prevent odors in the recovery tank,
remove the vacuum head when machine is
not in operation to allow air to circulate.
Diamond Products

DRY PICKUP

on
position.
"
"
Operator's Manual