Diamond Systems EMX-ESG Series Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Diamond Systems EMX-ESG Series. Diamond Systems EMX-ESG Series 17 pagina's. Emx i/o module with 2 gigabit ethernet, 6 serial ports, and 14 gpio
Pagina afdrukken5. CONNECTOR AND JUMPER LIST
5.1 Connector List
The following table summarizes the functions of the EMX-ESG's interface connectors. Refer to the Figure 2 for
connector and jumper locations. Signal functions relating to all of EMX-ESG's interface connectors are discussed
in detail in Section 6 of this document. Other connectors and jumper blocks on the board are reserved for
Diamond Systems' use only.
.
5.2 Jumper List
See Section 7 for information on configuring jumpers.
As a custom assembly option, EMX-ESG was designed with 0-ohm resistors that may be installed in place of the
jumpers for a more rugged assembly.
EMX-ESG User Manual Rev A.1
Connector
Function
J1
EMX Top
J2
EMX Bottom (not shown on drawing)
J3
GPIO
J4, J5, J6
Serial Ports
J7, J8
Ethernet Ports
J9
Ethernet LEDs
U10
GPS
Jumper
Function
J10
Serial Port Termination jumper
J11
Address and Protocol jumper
www.diamondsystems.com
Page 8