Panasonic PT-AE1000E Gebruiksaanwijzing afstandsbediening - Pagina 12
Blader online of download pdf Gebruiksaanwijzing afstandsbediening voor {categorie_naam} Panasonic PT-AE1000E. Panasonic PT-AE1000E 16 pagina's. Panasonic lcd projector operating instructions
Ook voor Panasonic PT-AE1000E: Gebruiksaanwijzing (28 pagina's)
Pagina afdrukken
Turning the power for home theatre
system devices on and off at once
(power supply macro function)
You can use the projector's remote control to turn the power on and off for home theatre system
devices that have been registered by the remote control.
Note:
At the time of purchase, a macro for turning the power on and off for PJ, DVD, VCR and AMP all at once is set.
Using the power supply macro
function
Note:
If the distance that the projector's remote control has to
operate is too far, or if the remove control receiver of the
home theatre system devices are obstructed, this operation
may not work correctly.
Check the locations and directions of the home theatre
system devices to make sure that they can all be operated.
1
Press "SYSTEM" for 3 seconds or more.
The power supply for all
registered devices will turn on.
The length of time required for the macro function to finish
operating effectively will vary depending on the number of
devices that have been registered.
Configuration de la fonction macro
d'alimentation
1
Press "SETUP" for 3 seconds or more.
2
Use the tilt button to select "PJ", and then
press "ENTER".
12 - E
NGLISH
3
Press "ENTER", 2 times.
The display will show the
devices hat have been
registered by the macro.
4
Use the tilt button to select the device to
be registered.
If a registered device is selected, the display will flash
faster.
5
Press "SYSTEM".
If a registered device is selected, the display will flash
faster.
To register or delete another device, repeat steps 4 and 5.
Clearing the macro function.
Clearing the macro function
Press "SYSTEM" once more.
The macro function will be cleared and the display will
flash more slowly.
6
When you have finished selecting devices,
press "ENTER".
To finish, press "SETUP".
(Example: When "USER3" is selected)