Panasonic PT-AE4000U Gebruiksaanwijzing - Pagina 16
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Panasonic PT-AE4000U. Panasonic PT-AE4000U 36 pagina's. Full high-definition home cinema projector
Ook voor Panasonic PT-AE4000U: Functionele instructies (50 pagina's), Brochure & specificaties (6 pagina's)
Pagina afdrukken
Basic Operation
Switching the projector on/off
Power cord
Connecting
J
1.
Make sure the shape of the power plug and the
AC IN terminal on the back of the projector match,
then push the plug all the way in.
2.
Align the side of the
the side guide rail of the AC IN terminal of the
projector and slide it in.
Disconnecting
J
1.
Unplug the power cord from the wall outlet.
2.
Depress the latch and slide the cover off.
NOTE:
•
Do not use other than the provided power cord.
•
Ensure all the input devices are connected and turned off before connecting the power cord.
•
Do not force the connector as this may damage the projector and/or the power cord.
•
Dirt or dust build-up around plugs may cause fire or electrical hazards.
•
Switch off the power to the projector when not in use.
Power indicator
Power indicator informs you of the status of the power.
When the TEMP indicator is flashing, the power
indicator will turn red, and you cannot switch on the
power.
Indicator status
No illumination or flashing
Red
Green
Orange
NOTE:
•
See "TEMP indicator" on page
•
While the projector is cooling the lamp, do not switch
•
The electric consumption in standby mode is 0.08 W.
E
16 -
NGLISH
power cord secure lock with
Rail guide
MAIN POWER is switched off.
Lit
MAIN POWER is switched on and the projector is in standby mode.
MAIN POWER is switched on (standby mode) and the POWER ON LINK is set to
YES.
•
Flashing
The power consumption is not much different when it is lit.
( See "VIERA Link Connection" of the functional instructions that is in the provided
CD-ROM.)
Flashing
The power button is switched on and the projector is getting ready to project.
Lit
Projecting.
Lit
The power button is switched off and the projector is cooling the lamp.
The power button is switched on again when cooling the lamp and recovering to
Flashing
projection mode. Recovery may take a while.
25.
3.
Place the latch to the latch catcher and press until
it clicks.
Latch
4.
Connect the power cord to a wall outlet.
3.
Slide the power cord secure lock up along the side
guide rail.
4.
Hold the plug and unplug it from the
terminal on the back of the projector.
Power indicator
Status
MAIN POWER off or unplug the power cord.
AC IN