Panasonic PT-D6000E Gebruiksaanwijzing - Pagina 28

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Panasonic PT-D6000E. Panasonic PT-D6000E 42 pagina's. Dlp based projector commercial use

Pagina afdrukken

1. Replacing the Lamp Unit

Monitor Lamp indicators

Managing the indicated problems

Indicators

Power indicator

Lamp1 (LAMP1) indicator

Lamp2 (LAMP2) indicator

Temperature (TEMP) indicator

Filter (FILTER) indicator

STANDBY(RED)/

If a problem should occur with the projector, the indicators will inform you. Manage the indicated problems as follow.

1. Confirm the status of all indicators and projector, and switch off the projector in proper way.

2. Find out the cause of the problem by status of each indicator.

3. Follow the instruction for each indication below and solve the problem.

4. Turn on the projector in the correct way and confirm the indicator is not indicating a problem any longer.

NOTE:

• If no problem is found or the problem remains, do not turn on the projector. Instead contact your nearest dealer.

 LAMP1/LAMP2 indicator

Lamp

indication

Indicates the time for

Lighting in red

replacing the lamp unit

Blinking in red

Lamp unit is not installed.

once

Blinking in red

Error is detected in the

3 times

lamp circuit.

 TEMP indicator

Lamp

indication

Warm-up status

Lighting in red

High temperature inside.

(WARNING)

The filter is excessively

Blinking in red

dirty and the ventilation is

once

poor.

Blinking in red

High temperature inside.

twice

(Standby condition)

Blinking in red

Cooling fan has been

3 times

stopped.

NGLISH - 28

LAMP

TEMP

FILTER

ON(GREEN)

Information

• Did you notice a "REPLACE

LAMP" message on the screen

when turning on the projector

power supply?

• Check the lamp unit

compartment.

• Did you turn the power back on

immediately after turning it off?

• Some error has arisen in the

lamp circuit.

• Check for fluctuation (or drop) in

the source voltage.

Information

• Did you turn on the power when

the ambient temperature was

lower than approx. 0 °C (32 °F)?

• Check the ventilation port is

blocked.

• Is the room air temperature too

high?

• Was the temperature warning

indication displayed?

STANDBY(RED)/

LAMP

TEMP

FILTER

ON(GREEN)

Check point

• This lamp monitor lights up when the lamp

unit used hours have reached 1 800* hours.

Request the dealer to replace the lamp unit.

* 2 800 hours for PT-D5000E only.

• Install the lamp unit.

• When lamp unit is installed and still having

the indicator lights, contact to the dealer.

• Wait until the lamp has cooled off, and then

turn on the power.

• Turn off the POWER switch of the projector

properly and contact your nearest dealer.

Check point

• Wait about 5 minutes in the current status.

• Install the unit in a location having an

ambient temperature from 0 °C (32 °F) -

45 °C (113 °F).

• Remove the object that is blocking the

ventilation port.

• Move the projector to a temperature of 0 °C

(32 °F) - 45 °C (113 °F) and the humidity of

20 % to 80 % (no condensation).

• Turn off the POWER switch of the projector

in proper way and contact the dealer.

• Turn off the POWER switch of the projector

in proper way and contact the dealer.

Remedial measure