Diamond Tech International Power Miter II Bedieningshandleiding - Pagina 6

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Diamond Tech International Power Miter II. Diamond Tech International Power Miter II 9 pagina's. Chop saw

Pagina afdrukken

Unpacking

WARNING: To reduce the risk of injury from unexpected starting or electrical shock, do not

plug the power cord into a source of power during unpacking and assembly. This cord

must remain unplugged whenever you are working on the saw.

WARNING: If any part is missing or damaged, do not plug the saw in until the missing or

damaged part is correctly replaced.

Basic Saw Operations

Body and Hand Position

Never place hands near cutting area. Place hand at least 4" from path of blade.

Hold workpiece firmly to the fence to prevent movement toward the blade.

When holding the workpiece to the left side of the blade, always use your left hand. Use your

right hand to hold the workpiece to the right side of the blade.

Before making a cut, make a "dry run" with the power off so you can see the path of the

blade.

Keep hands in position until trigger has been released and the blade has completely stopped.

WARNING: Do not try to cut short pieces. You cannot properly support the workpiece and

keep your hand down the required distance from the blade.

Miter/ Angle Cut

Loosen the Miter Lock Bolt. Rotate miter/angle guide clockwise from 0° to 45°. Retighten

miter lock bolt. With power off, test blade alignment to confirm that blade will not cut into

the miter/angle guide.

Occasionally the path of the blade will shift out of adjustment. This should be tested for

prior to using the saw. To test for this possibility, please do the following:

1. Unplug the saw.

2. With the miter/angle guide set at 0° pull

the blade down as far as possible.

3. If the saw clears the fence return the

blade to the top position.

4. Turn the miter/angle guide to 45° and pull

the blade down as far as possible.

5. If the blade clears, the saw is adjusted

properly. If during either test the blade hits

the fence, continue with step 6.

6. Loosen the top front left bracket screw.

(see diagram on page one, screw labeled

blade adjustment screw)

7. Repeat steps 2-4. Grasping the handle, move the blade either left or right until the

blade clears the fence at both tested angles.

8. After the blade has been adjusted to clear the fence, retighten the screw in step 6.

9. Repeat steps 2-5.

Fence

Miter/Angle Guide