Panasonic PT-FW430 Spec Bestand - Pagina 10
Blader online of download pdf Spec Bestand voor {categorie_naam} Panasonic PT-FW430. Panasonic PT-FW430 15 pagina's. Panasonic pt-fw430u: specifications
Pagina afdrukken
S
F
P
E
C
I
L
LCD Projector
Serial connector
The serial connector complies with RS-232C. To control the projector from a personal computer, com-
mands must be input through communication software, based on the format and satisfying the commu-
nication conditions shown below.
Pin assignments and signal names
6
9
1
5
D-sub 9-pin (female)
Serial input
Communication conditions (factory setting)
Signal level
Synchronization method
Baud rate
Parity
Character length
Stop bit
X parameter
S parameter
Basic format
Transmission from the computer begins with STX, then the ID, command, parameter, and ETX are sent
in this order. Add parameters according to the details of control.
STX
A
D
I1 I2
Start
(2 bytes)
(1 byte)
ID 2 characters
(2 bytes)
ID designator:
01 to 06: Projector ID number
ZZ: All units (ID ALL)
CAUTION
• It may not be possible to send or receive commands for about 10 to 60 seconds when the lamp is first turned on. If this occurs, wait for 60 sec-
onds, then try sending or receiving again.
• When sending multiple commands, be sure to wait for at least 0.5 second after receiving a response from the projector before sending the next
command.
• Additional time is sometimes required for response due to processing inside the projector. Set the time-out period for command response to 10
seconds or more.
• When using two or more units, set different IDs for each unit.
As of March 2011
SFL11M005-1
E
No.
Signal name
Description
1
–
NC
2
TXD
Send data
3
RXD
Receive data
4
–
NC
5
GND
Ground
RS-232C-compliant
Start-stop synchronization
9,600 bps
None
8 bits
1 bit
None
None
;
C1
C2
C3
Semicolon
(1 byte)
Command
(3 bytes)
(Control and/or query commands)
No.
Signal name
6
–
7
RTS
8
CTS
9
–
:
P1 P2 ... Pn
Colon
(1 byte)
Parameters
(undefined length)
PT-FW430
Description
Connected internally
Connected internally
Connected internally
NC
ETX
End
(1 byte)
1 0 / 1 4