Panasonic PT-L6600E Gebruiksaanwijzing - Pagina 43

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Panasonic PT-L6600E. Panasonic PT-L6600E 50 pagina's. 3600 ansi lumens sxga lcd projector 4200 ansi lumens xga lcd projector
Ook voor Panasonic PT-L6600E: Brochure & specificaties (6 pagina's), Brochure & specificaties (6 pagina's)

Pagina afdrukken

Lamp unit replacement steps

Caution

• After 2000 hours of operating the same lamp, it is only possible to operate the unit for approximately 10

minutes. Replace the lamp and steps 8 to 14 must be completed within 10 minutes:

1. Turn the power off by following the steps on page 23, remove the power plug and

confirm that the surroundings of the lamp unit have cooled off.

2. Using a Philips screwdriver, remove the

4 screws on the lamp unit cover located

on the rear of the projector.

3. Remove the lamp unit cover by pulling it

forward.

Caution

• Be careful not to break the tab located in the

centre of the lower side of the lamp unit cover.

4. Use a Phillips screwdriver to loosen the

two lamp unit fixing screws until the

screws turn freely. Then hold the handle

of the lamp unit and gently pull it out from

the projector.

Caution

The lamp unit will be hot after it has been

used.

You might get burned if you touch it while it is still hot.

5. Install the new lamp unit.

6.Use a Phillips screwdriver to securely tighten the 2 lamp unit fixing screws.

7. Install the lamp unit cover, and then use

a Phillips screwdriver to securely tighten

the lamp unit cover fixing 4 screws.

Caution

• Firmly install the lamp unit and lamp unit cover.

If not installed firmly, a protection circuit will

function and the power will not be turned on.

Fixing screws

Lamp unit cover

Tab

Lamp unit 1

Lamp unit 2

Handle

Lamp unit 1

Lamp unit 2

Fixing screws

PUSH

OPEN

Lamp unit cover

Tab