Panasonic PT-L750E Gebruiksaanwijzing - Pagina 28

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Panasonic PT-L750E. Panasonic PT-L750E 36 pagina's. Wired and wireless/portable projector
Ook voor Panasonic PT-L750E: Brochure & specificaties (4 pagina's)

Pagina afdrukken

Using the cable cover

When installing the projector to the ceiling, the accessory cable cover can be

used to cover the terminals or cords after removing the cut-away parts.

# Use pliers or similar to break the

perforated sections of the cut-

away parts.

Perforated sections

$Work the cut-away parts back and

forth several times to break the

fixing tabs. Smooth off any jagged

edges if necessary.

Hook2

Hook1

Fixing tabs Fixing tabs

%Pass the power cord through cut-

away part S, and pass the other

cables through cut-away part L,

and then insert the tabs of the

cable cover into the mounting

holes in the projector.

&Push hook 2 until it locks into

place.

Cut-away part S

Cut-away

part L

54-E

NGLISH

'Tighten the screw by turning it

clockwise.

Screw

Refer to page 53 for details on

removing the cable cover.

NOTE:

Do not cover the air inlet ports when

using the cable cover as stated

above.

Do not place any heavy objects on

the cable cover to prevent it from

being removed.

Do not bend the cables greatly,

otherwise it will be difficult to attach

the cable cover.

Remove the cable cover when

cleaning or replacing the air filter.

Using the remote terminal

Using the remote terminal built into this projector, it is possible to operate the

projector from an external location from where infrared remote control signals

cannot be received, by using a remote control panel.

Pin assignment and control

Signal Name

GND

POWER

INPUT SEL3

D-Sub 9-pin (female)

INPUT SEL1

external appearance

(

INPUT SEL2

)

ENABLE

Short pin 1 and pin 9 when controlling.

#Power ON/OFF

Pin No.

Setting

$ - #

Short

Open

Lamp

OFF (standby)

$Switching the input mode

Pin No.

% - #

Open

' - #

Open

Short

( - #

Open

Input Signal

RGB1

RGB2

NOTE:

B The POWER, RGB and VIDEO buttons on the remote control unit and

projector will not operate when pins 1 and 9 are shorted. RS-232C

commands will also be ignored. If the projector is connecting a personal

computer using an optional wireless card or LAN card, the "POWER" or

"SWITCH INPUT MODE" will not function.

B Do not short pins. 1, 2, 3, 5, or 6 when pin 9 is open. If this is done, the

projector will ignore signals from the remote control unit.

Description

Ground

Power ON

Input signal select3

Input signal select1

Input signal select2

Enables remote terminal control

Setting

Short

Open

Short

Open

Short

Open

Short

RGB3

VIDEO

S-VIDEO

DVI

NGLISH

-55