Panasonic PT-LB10U - Mobile Projector XGA 2000 Lumens Gebruiksaanwijzing - Pagina 6
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Panasonic PT-LB10U - Mobile Projector XGA 2000 Lumens. Panasonic PT-LB10U - Mobile Projector XGA 2000 Lumens 33 pagina's. Micro portable xga lcd projector
Ook voor Panasonic PT-LB10U - Mobile Projector XGA 2000 Lumens: Brochure & specificaties (4 pagina's)
Pagina afdrukken
NOTICE:
B This product has a High Intensity Discharge (HID) lamp that contains a
small amount of mercury. It also contains lead in some components.
Disposal of these materials may be regulated in your community due to
environmental considerations. For disposal or recycling information
please contact your local authorities, or the Electronics Industries
Alliance: <http://www.eiae.org.>
Accessories
Check that all of the accessories shown below have been included with your
projector.
Card remote control unit
Lithium battery for
(TNQE239 x1)
remote control unit
(CR2025 x1)
POWER
INPUT
VIDEO
RGB
AUTO
MENU
SETUP
ENTER
Power cord
(K2CG3DR00005 x 1)
FREEZE
SHUTTER
STD
VOLUME
D.ZOOM
INDEX
WINDOW
PROJECTOR
PT-LB10NTU only
CD-ROM
Wireless Card
(TQBH9005 x1)
(N5HBD0000028 x1)
10-E
NGLISH
RGB signal cable
[1.8 m (5´10˝),
K1HA15DA0002 x1]
Carrying bag
(TPEP009 x 1)
Hexagon wrench
(TKLA0701 x1 )
Before use
Caution when moving the projector
Be sure to attach the lens cover before moving the projector.
The projection lens is extremely susceptible to vibration and shocks. When
moving the projector, use the accessory carrying bag. When placing the
projector inside the carrying bag, position it so that the lens is facing upward.
Do not put anything else in the bag other than the projector and the cables.
Cautions regarding setting-up
Avoid setting up in places which are subject to vibration or shocks.
The internal parts can be damaged, which may cause malfunctions or
accidents.
Do not set up the projector near high-voltage power lines or near
motors.
The projector may be subject to electromagnetic interference.
If installing the projector to the ceiling, ask a qualified technician to
carry out all installation work.
You will need to purchase the separate installation kit (Model No.ET-PKC80).
Furthermore, all installation work should only be carried out by a qualified
technician.
If using this projector at high elevations (above 1 400 m), set the "FAN
CONTROL" to "HIGH". (Refer to page 45.)
Failure to observe this may result in malfunctions.
E
-11
NGLISH