Diamondback SE Installatiehandleiding

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Diamondback SE. Diamondback SE 2 pagina's. Hard tonneau cover for '15–up colorado & canyon with the 61.7" cargo box
Ook voor Diamondback SE: Installatiehandleiding (2 pagina's), Installatiehandleiding (2 pagina's), Installatiehandleiding (2 pagina's), Installatiehandleiding (2 pagina's)

Pagina afdrukken

(800) 935-4002 | DIAMONDBACKCOVERS.COM

INSTALLATION GUIDE

60 minutes

Normal Install Time

PARTS INCLUDED:

Cab Panel

Center Panel

Tailgate Panel

TOOLS REQUIRED:

9/16"

Ratchet Wrench

Socket

POSITION THE PANELS

Place the center panel across the

center of bed, cheated slightly toward

the tailgate.

Make the sure the

arrow sticker on the

underside of the

center panel is

pointing toward the

tailgate.

Repeat step three for the

tailgate panel.

Position the cover

front to back so that

the leading edge of the

cab panel lines up with

the leading edge of the

bulkhead.

Keep an eye out for these icons:

Safety Catch

Gas Springs (4)

Cap Clamps (4)

7/16"

1/8"

Drill

Socket

Hex Key

Finger-tighten the cap clamps at

each corner of the center panel.

The bottom halves of the cap

clamps should be in the deck

rail system.

IMPORTANT!

Important installation information

Grommets (2)

1/8" or

1" Bit

Marker

3/16" Bit

Slide the cab panel onto the center panel by mating their hinges. Close the

cab panel slowly. Make sure it doesn't hit your cab.

To avoid hinge damage, do not close the

panel until hinges are fully mated: Tilt the

panel past 90° and push to the left until the

hinge lock tabs interlock.

Center the DiamondBack cover

side to side on the truck.

Tighten the cap

clamps with a

9/16" socket.

Retighten your clamps after 100

miles. Check them every time

you haul on top.

2005-UP TOYOTA TACOMAS

with the 60.3" Bed

Helpful Hints

Tips to assist installation

PRE-INSTALLATION NOTES:

1. Install the Bulkhead Prep Kit before installing

your DiamondBack cover. Refer to the Bulkhead

Prep Kit Installation Guide for details.

2. If you are installing a Low-Profile Cab Guard

or HD Cab Guard, you should mount it prior to

installing your DiamondBack. Refer to the Cab

Guard Installation Guide for details.

3. If you are installing a Side-Loading ATV Carrier

on cargo bed longer than 6 feet, you must mount

the center panel adapter bars prior to installing

your DiamondBack HD. Refer to the Side Adapter

Bars Installation Guide for details.

4. It's possible for one person to install a DiamondBack

solo, but the whole process, especially positioning

the panels and adjusting the lock rods, is much

easier with two people.

Mating hinges is

easiest when you

line up the longer,

left hinge pin first.

CONTINUED ON OTHER SIDE