Panasonic RM-G45PA Servicehandleiding - Pagina 7
Blader online of download pdf Servicehandleiding voor {categorie_naam} Panasonic RM-G45PA. Panasonic RM-G45PA 37 pagina's.
Pagina afdrukken3 Schematic Diagram Notes
• This schematic diagram may be modified at any time
with the development of new technology.
Notes:
S602:
Mode switch (MODE)
S603:
Volume mode switch (V MODE)
S651:
Audio switch (AUDIO)
S652:
CB select switch (CB)
S653:
Preset channel 1 switch (CH1)
S654:
Preset channel 2 switch (CH2)
S655:
Preset channel 4 switch (CH4)
S656:
Preset channel 5 switch (CH5)
S658:
I-com switch (I-COM)
S659:
Auto select/repeat switch (A.SEL/RPT)
S660:
Preset channel 3 switch (CH3)
S661:
Preset channel 6 switch (CH6)
S662:
FM1 select switch (FM1)
S663:
FM2 select switch (FM2)
S664:
Weather band select switch (WB)
S665:
Aux switch (AUX)
S666:
AM select switch (AM)
S667:
CD select switch (CD)
• Indicated voltage values are the standard values for the unit
measured by the DC electronic circuit tester (high-
impedance) with the chassis taken as standard. Therefore,
there may exist some errors in the voltage values,
depending on the internal impedance of the DC circuit
tester.
No mark
: FM
( )
: AM
< >
: WB
• Important safety notice:
Components
identified
characteristics important for safety.
Furthermore, special parts which have purposes of fire-
retardant (resistors), high-quality sound (capacitors), low-
noise (resistors), etc. are used.
When replacing any of components, be sure to use only
manufacturer's specified parts shown in the parts list.
• The supply part number is described alone in the
replacement parts list.
• Voltage and signal line
: Positive voltage line
: FM signal line
: FM/AM OSC signal line
: AM signal line
: WB signal line
: WB OSC signal line
: FM/AM/WB Vcap cont. signal line
: Main signal line
Caution!
IC and LSI are sensitive to static electricity.
Secondary trouble can be prevented by taking care during
repair.
Cover the parts boxes made of plastics with aluminum foil.
Ground the soldering iron.
by
mark
have
special
Put a conductive mat on the work table.
Do not touch the legs of IC or LSI with the fingers directly.
7
RM-G45PA