Panasonic RXD27 - RADIO CASSETTE W/CD Gebruiksaanwijzing - Pagina 6
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Panasonic RXD27 - RADIO CASSETTE W/CD. Panasonic RXD27 - RADIO CASSETTE W/CD 12 pagina's. Portable stereo cd system
Ook voor Panasonic RXD27 - RADIO CASSETTE W/CD: Gebruiksaanwijzing (12 pagina's)
Pagina afdrukken
2
1
1
Press [TUNER/BAND –AUTO PRESET] to select "FM" or
"AM".
(Unit comes on.)
2
(Omit this step if using the remote control)
If "
" is on the display, press
[TUNE MODE] to clear it.
3
Press [– /
] or [
to the desired station.
Automatic tuning
Press and hold [–/
display starts to change. A station with good reception is automati-
cally selected and the process stops.
To stop automatic tuning, press [–/
Note
Automatic tuning may stop on a frequency where there is no station if
there is interference. Press [–/
4
Adjust the volume.
To improve reception
FM: Extend the whip antenna and adjust its direction.
AM: Adjust the position of the unit.
If noise is excessive in the FM stereo mode
Press [PLAY MODE] on the remote control.
("MONO" lights up.)
Sound will be produced in monaural, but this
also reduces noise.
Press the button again to cancel. ("MONO"
goes out.)
For area except for United Kingdom and Continental Europe
AM allocation setting
Before receiving AM broadcasts, be sure to select the correct allocation
setting (either 9 kHz or 10 kHz) for your area.
First press [TUNER/BAND –AUTO PRESET] to select AM. Next, press
and hold [
]. The display changes in a few seconds to show the current
lowest AM frequency. Continue to hold down the button.
When the minimum frequency changes, release the button.
Changing the step erases all preset stations.
Repeat the above to change the step back.
6
RQTT0627
Normal tuning
3 4
/ +] to tune
] or [
/+] then release when the frequency
] or [
/+] again.
] and [
/+] to tune if this occurs.
The radio
Preset the stations (twenty FM and twelve AM) to make tuning simpler.
2
Do the following once each for FM and AM.
Preparations: Press [TUNER/BAND –AUTO PRESET] to select "FM" or
"AM".
Press and hold [TUNER/BAND –AUTO PRESET] on the main
unit until "AUTO" is displayed.
The tuner presets stations it can receive into the channels.
Remote control only
Presets one station at a time.
Press [PGM/CLEAR].
1
2
While "
" is flashing (about 10
seconds)
Press the numbered buttons to
select a channel.
To select channel 10 or higher
>
e.g.12: [
10]
=
Repeat the above to preset other stations.
The station occupying a channel is erased if another station is preset in
that channel.
To listen to preset channels
Press [TUNER/BAND –AUTO PRESET] to select "FM" or
1
"AM".
(Omit this step if using the remote
2
control)
Press [TUNE MODE] to display
"
".
Press [– /
3
the desired channel.
(FM:1-20, AM:1-12)
Remote control:
[
/
ALBUM](
or [ALBUM
Preset tuning
2
1
RX-D29
3
1
RX-D27
Automatic presetting
Manual Presetting
[1]
[2]
] or [
/ +] to select
PRESET TUNE)
/
](PRESET TUNE
)
Preset channel