DIAQUIP QDS-500 Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DIAQUIP QDS-500. DIAQUIP QDS-500 12 pagina's. Diamond drilling drill stands

DRILLING STAND FUNCTIONAL DESCRIPTION

Fastening the drill rig

Once the desired position of the rig is determined, Use a concrete anchor to secure the rig.

Drill a suitable sized hole for the anchor with a hammer drill.

Drive in the anchor.

Use a long threaded rod with a large washer and nut to secure the base.

Before fully tightening the nut, use a spirit level to check if the stand is level. If needed, loosen

the locknuts and adjust the four leveling bolts to achieve levelness. Then retighten the locknuts.

Now fully tighten the securing nut which affixes the base to the work surface.

NOTE: We recommend using the optional Anchoring Plate for the most secure possible

fixing of the base to the workpiece. Place the anchoring plate on the base with the

threaded rod through the hole. Then add the washer and nut. Tighten secularly.

(QDS-500 & QDS-800 only).

Note: If mounting on a wall, it is usually more convenient to secure the stand with the

motor head removed. Using the 19mm combination wrench, loosen the cradle lock bolt

on the carriage to lift the motor head up and away. Once the stand is fixed, the motor

head may be re-installed on the stand. Be sure to securely tighten the cradle lock bolt(s).

Note: If additional security is needed, use the jackscrew with an appropriate length

bracing column between the opposite wall or ceiling dependent on where the rig is

situated. Be sure to risk assess the surrounding wall/ ceiling construction before using

this method of anchoring the rig.

ADJUSTING THE DRILLING ANGLE

0 to 45 degrees

The drilling angle can be tilted from 0 to 45 degrees. To adjust

the angle, use the crank handle as a wrench and loosen the

angle clamp bolt. Refer to the scale on the column indicating

the angle. Adjust to the desired angle and tighten the clamp.

CAUTION: Do not overtighten the clamp. Only tighten the

necessary amount to make the clamp secure. Overtightening

could distort the column.

/06