DiaTecne PulsePen WPP001-ETT Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DiaTecne PulsePen WPP001-ETT. DiaTecne PulsePen WPP001-ETT 16 pagina's.

Tonometric unit: wTn1

1. On / Off button: keep pressed for about 1 sec.

2. Cap for battery replacement: pull away from the tonometer's body. Push the old battery toward you from

the hole of the opposite side of the opening. Gently insert the new fresh battery following the polarity

specified on the label. Put the cap on and push it until snap occurs.

3. Active part of the tonometric sensor.

ECG unit: wEc1

1. On / Off button: keep pressed for about 1 sec.

2. Cap for battery replacement: pull away from the unit's body. Extract the old battery. Gently insert the

new fresh battery following the polarity specified on the label. Put the cap on and push it until snap

occurs.

3. Patient cable sockets.

Signal Receiver unit: wRs1

1. Led indicates the operating mode. This Led blinks green when the PulsePen software is not running or if

the USB driver is not correctly installed. This Led is fixed green during normal operations while it is red

during reprogramming / update. 

! 2

User Manual PulsePen - V. 4.6