EasyPet EP-380R Gebruikershandleiding - Pagina 11

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} EasyPet EP-380R. EasyPet EP-380R 19 pagina's. Easypet rechargeable multi-dog remote training system

Pagina afdrukken

long as correction level indicator is not shown as "– –" on the LCD screen (which is

the "No Transmit" mode for the transmitter).

4.2

Make sure the collar receiver is turned ON. (The collar receiver will be turned on

automatically after the charging or please refer to Step 3: Turn ON/OFF the Collar

Receiver) .

4.3

Press and hold down the power button on collar receiver firmly (you might find

it easier to hold it down firmly with finger nail), a green indicator light should come

up and stay on in the collar receiver while the button is pressed down (Please note

that the power button needs to be held down firmly until the matching up is

completed).

4.4

Short press the "

on the transmitter will come up, which means it is sending out a command to the

collar receiver. On the collar receiver, the green LED light will start flashing on and

off (it will be a proper on and off flashing but not just a flickering) which indicates the

matching-up procedure is completed successfully.

4.5

You may now release the power button on the collar receiver and start using the

collar receiver from the registered channel.

If you find it difficult to hold down the power button on collar receiver properly

during the whole matching up procedure, you might find the following way easier to

perform the matching up:

With both transmitter handset and collar receiver turned on, send out a correction

command from the transmitter handset by short pressing the T button on the

handset. The handset will send out a command to the collar receiver and the signal

will last for 2 seconds. WITHIN THESE 2 SECONDS, press and hold down the power

button on collar receiver firmly (you might find it easier to hold it down firmly with

finger nail), the green LED light on collar receiver will come up and start flashing on

and off. You may now release the power button on collar receiver and the matching

up is completed.

For multi-dog training setup, simply follow the above matching-up procedures to

match up the collar receivers one by one. Each time, choose a different dog channel

for the new collar receiver.

The matching code will be stored in the receiver automatically and there is no need

to repeat the matching procedures after switching on/off or recharging the collar

receiver. *

" button on transmitter handset. The green indicator LED light