•
Do not drop, throw or try to bend the product or its accessories.
•
Do not use harsh chemicals, cleaning solvents, liquid cleansers or aerosols to clean the product or its
accessories.
•
Do not paint the product or its accessories.
•
Store the product and its accessories at temperatures between 0°C to 40°C
•
Please check local regulations for disposal of electronic products
•
Damage requiring service.
Contact an authorized service technician or provider under the following conditions:
•
The product has been damaged by exposure to liquid, dropped, subject to impact or damaged.
•
There are noticeable signs of overheating.
•
The product does not operate normally when you follow the operating instructions.
•
Avoid hot areas.
The product should be placed away from heat sources such as radiators, heat registers, stoves, or other
products (including amplifiers) that produce heat.
•
Avoid using the product after a dramatic change in temperature.
When you move the product between environments with very different temperature and/or humidity ranges,
condensation may form on or within the product. To avoid damaging the product, allow sufficient time for the
moisture to evaporate before using the product.
NOTICE: When taking the product from low-temperature conditions into a warmer environment or from
high-temperature conditions into a cooler environment, allow the product to acclimate to room temperature
before turning on power.
•
Avoid pushing objects into the product.
Never push objects of any kind into cabinet slots or other openings in the product. Slots and openings are
provided for ventilation. These openings must not be blocked or covered.
•
Adjust the volume.
Turn down the volume before using headphones or other audio devices.
•
Cleaning the product.
Unplug the product from its power source before cleaning. Use a damp cloth for cleaning, but NEVER use
water to clean the product. Clean and dry skin that regularly comes in contact with the headset. If there is
any itching, eczema, swelling, irritation of the skin, or you experience any discomfort, please discontinue use
and consult your physician.
About Vive headset regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of 0PJT100.
Your product's FCC ID is NM80PJT100. This FCC ID can also be found printed on the Vive headset.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with your
0PJT100.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 12 Volts DC, maximum
1.5 Amp power supply unit.
About Vive controller regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of 2PR7100.
Your product's FCC ID is NM82PR7100. This FCC ID can also be found printed on the Vive controller.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with your
2PR7100:
The Battery Pack has been assigned a model number of B0PLH100.
THE BATTERY IS NOT FULLY CHARGED WHEN YOU TAKE THE DEVICE OUT OF THE BOX.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 5 Volts DC, maximum
1 Amp power supply unit.
RF exposure:
To comply with the IC RF exposure compliance requirements, this device and its antenna must not be co-located
or operating in conjunction with any other antenna or transmitter.
Pour se conformer aux exigences de conformité RF canadienne l'exposition, cet appareil et son antenne ne
doivent pas être co-localisés ou fonctionnant en conjonction avec une autre antenne ou transmetteur.
5
Pagina afdrukken