Easyrig 4 Vario Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Easyrig 4 Vario. Easyrig 4 Vario 12 pagina's.

Using the Easyrig 4 Vario

It is as simple to put the Easyrig 4 Vario on as it is with a backpack. Just

don't forget to adjust it so it feels comfortable.

The weight of the camera should primarily be on your hips. It is important

that the support bar is vertical – if it is lopsided the load will be unevenly

distributed on the hips and the camera might hit the bar.

The hip belt should be tightened so that the rig doesn't slide down or

around the hips. The shoulder straps are mainly for balancing the Easyrig,

and prevent it from tilting.

If the support arm is too high or too low, first try adjusting the support

arm in relation to the hip and back support, or change position of your

hips. It is also possible to adjust the tube inside the support bar, but that

might require adjusting the tightness of the suspension line. Note that

there must not be more than 10 cm (4 in) between the lower end of the

tube and the adjustment ring.

When attaching the hook onto the camera, you might find it easier to put

the camera on a table or a bench first. Try and find the right balance of the

camera before you secure the hook.

Don't forget to fasten the safety line.

Hip shots

Easyrig 4 Vario gives you the freedom to shoot from various levels.

You simply move the camera down from your shoulder as you would

in an ordinary handheld situation – only now you don't feel more than

a fraction of the camera's weight. When shooting at hip level, lean

backwards when pushing the camera forward, thus minimizing the load on

your back. The length of the suspension line makes it possible to move the

camera as far as your arms reach.