Bionaire BH3930 Gebruiksaanwijzing - Pagina 5

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Bionaire BH3930. Bionaire BH3930 6 pagina's. Digital console heater

Pagina afdrukken

2. When in "Auto" mode, press the (-) button on the

remote to decrease the "Set" temperature. The

unit scrolls one digit at a time in a continuous loop.

UNIT OPERATION WITHOUT REMOTE

A. Remote and Unit are OFF:

1. Press the Mode button on the unit the first time. The

"Low" light illuminates and the unit runs in "Low" mode.

The power light turns on.

2. Press the Mode button a second time to run in "High"

mode (1500 Watts).

3. Press the Mode button a third time and the unit shuts

off.

Figure 3

low

LOW

(1000 Watts)

Note: The "auto" light only illuminates when the unit is set

to "auto" mode by the remote.

B. Remote is ON and Unit is ON:

1. Press the Mode button on the unit. The unit will then

switch "Modes"; either from "Low" to "High", "High" to

"Off" or "Auto" to "Off" . The unit's lights will reflect the

change. The Remote will display a different mode – the

mode in which it was left. If a button is pressed on the

Remote, the Remote's signal will override the "Mode"

on the unit and the two will be back in sync.

TIMER FUNCTION:

Using Timer to turn unit off

1) Hold mode button for 2 seconds to unlock remote.

2) Push + and - together.

2.1) "timer" turns on. 1 Hr appears on the

screen.

3) Push + or - to adjust the number of hours the unit will

run before it automatically shuts itself off.

HIGH

(1500 Watts)

high

auto

AUTO

mode

MODE

3. Avoid overloading your circuit by not using other high

wattage appliances in the same outlet. At 1500 Watts,

this unit draws 12.5 Amps.

Note: The power light will remain lit during operation

ASSEMBLY INSTRUCTIONS

Wheel Assembly

Tools required for assembly: Phillips head screwdriver

Carefully unpack your Bionaire

recommended to save the box for off-season storage).

You will find the following pieces:

1. Four casters (wheels)

2. Four screws

WARNING DO NOT ATTEMPT TO OPERATE THE

HEATER WITHOUT THE WHEELS IN PLACE

Casters

(Wheels)

Caster

Platform

Fig. 1

3. Slide the caster platform into the bottom of the plastic end

cap, following the grooves (shown in Fig. 1).

4. Repeat this sequence on the other side of the heater, making

sure both sides are secure.

5. Return the console to its upright position.

FIRST USE ONLY:

1. Put batteries into Remote. The "Room" temperature is

displayed at all times. (Use 3 AAA batteries only, do not

mix alkaline and heavy duty batteries)

2. Plug unit into outlet. The first time the unit is plugged

in, it will beep every two seconds until it is synced with

the remote. To sync unit with remote follow the below

steps:

Unlock remote. (This must be done before each use of

the remote) To Unlock remote, hold down the mode

button for 2 seconds until the lock symbol disappears

from the screen. Once the remote is unlocked, press

the mode button again and the unit will quickly beep 5

times telling the user the signal was received. DO NOT

heater from the box (it is

3. Two caster (wheel platforms)

1. Make sure the unit is

unplugged. Using a slotted

X 4

or Phillips head screwdriver,

attach two casters to each

caster platform.

2. Carefully turn the unit over

so the caster platforms can

be attached.