Alpha Delta DX-CC Installatie-opmerkingen

Blader online of download pdf Installatie-opmerkingen voor {categorie_naam} Alpha Delta DX-CC. Alpha Delta DX-CC 4 pagina's. 82 ft. long "no trap"
Ook voor Alpha Delta DX-CC: Instructieblad (6 pagina's)

Pagina afdrukken

ALPHA DELTA DX-CC 82 FT. LONG "NO TRAP"

INSTALLATION NOTES

**Due to the fact that the ALPHA DELTA DX-CC antenna approximates a half

wave dipole (although greatly reduced in length), the method of mounting or

installing it does not present some of the problems associated with other types of

antennas. Towers, trees, wooden utility masts, etc. may all be employed as the

support structure for the ALPHA DELTA DX-CC!

*Refer to Figure No. 1: The DX-CC may be installed as in inverted seem flat top

dipole, sloping dipole, etc. The inverted vee configuration seems to be the

easiest for most amateurs to utilize. It has several benefits, such as requiring but

a single central support structure for the DX-CC center insulator. Remember,

though the ALPHA DELTA DX-CC was designed for compromise installations

where there are space limitations. A little thought will allow the DX-CC to be

installed in spaces normally thought to be too small for an antenna for these

frequency bands!

*Tower mounting height for the DX-CC will require some form of "stand-off" for

support of the DX-CC center insulator. A spacing of 18" or more away from the

tower will rove adequate.

*Mounting height for the DX-CC is not overly critical. However, as with most half-

wave antennas, the higher and in the clear, the better. Let the space you have

available dictate the mounting height and scheme of installation. The antenna

has been tested at a height of 35 ft. Lower heights may cause higher VSWR.

*The introduction of your DX-CC into a tower system employing multiple guy

wires or other wire antennas may cause detuning of the DX-CC antenna. This

may be evidenced by a shift in the resonant frequency or increase in the

minimum VSWR of the antenna. Try to keep the DX-CC as "in the clear" as

possible. Installing the DX-CC so that it is in a different plane than guy wires will

help, as will "breaking" the guy wires with strain insulators. For some

installations, it may be necessary to employ the use of an antenna tuner to

overcome this detuning situation.

*The DX-CC utilizes the exclusive ALPHA DELTA ISO-RES coil principle for

shortening and multibanding an antenna. The ISO-RES is not a trap, due to the

fact that there isn't a trap capacitor being used. Thus, the DX-CC is a much lower

"Q" antenna than one that would be constructed using true traps! This allows the

DX-CC to be broader in bandwidth than is possible with a trap-type antenna of

equal size. The lower "Q" also allows the user to employ a moderate range