Dickson TH803 Aan de slag

Blader online of download pdf Aan de slag voor {categorie_naam} Dickson TH803. Dickson TH803 6 pagina's. Temperature & humidity recorder

Pagina afdrukken

Default Recorder Settings

7-day chart rotation

+32 to 120F (TH800/02)

-20 to +120F (TH803/05)

Quick Start

1. Remove the protective pen caps.

2. Insert batteries and plug in AC adapter.

(See Figure 3.) (TH8 requires 4 AA batteries only.)

The unit will power on.

3. The instrument will move pen(s) to the appropriate

readings.

4. Install the chart that matches the Dip Switch settings

Press the Pen Home key to move the pens to the

outside of the chart. The pen is automatically raised

off the chart.

Remove the old chart, place the new chart on the

Chart Hub being certain that the edge of the chart

slides under the Chart Guide Clips located at the

outside of the chart.

5. Set the appropriate time. There are two ways to

adjust the chart and set the appropriate time:

a. Set the chart time manually by inserting a coin into

the groove in the chart hub and turning clockwise

until the correct hour (and day if applicable) on the

chart is referenced to the timing arrow (just to the

right of the pen tip on the dial).

This feature should be used for fine adjustments only.

Display Symbols TH8

Figure 1

Low battery

indicator

Battery enabled

www.DicksonData.com • 1-800-323-2448 • Fax 1-800-676-0498

Getting Started

Temperature & Humidity Recorder

b. To adjust the chart time, press and hold

Adjust-Up and Adjust-Down buttons located

on the back of the unit next to the dip switch (see

Figure 3).

The green LED will blink rapidly for about five

seconds, then the LED will remain solid green.

While in this state the Adjust-Up button will move

the chart backward (counter clockwise) and the

Adjust-Down button will move the chart forward

(clockwise).

Rotate the chart until the correct hour (and day if

applicable) on the chart is referenced to the timing

arrow. Once you have set your chart, press the Pen

Home button to exit Chart Adjust Mode. The unit

will take one minute to exit the Chart Adjust Mode

once Pen Home is pressed.

Press Pen Home to move the pens back onto

the chart.

6. Place the TH8 recorder on a flat vibration-free

surface. Be sure it is in a vertical position and level.

For best performance and longevity, the location

should be a clean environment, free from dust

and corrosive fumes. Do not exceed temperature

specifications.

Wall Mount Keyhole slots are provided on the TH8

recorder for wall mounting.

MAX

F or C

MIN

For setting alarms only

TH800/02/03/05

Current reading

Flashing "ALRN" when

in alarm condition