Dickson TK856 Aan de slag - Pagina 3

Blader online of download pdf Aan de slag voor {categorie_naam} Dickson TK856. Dickson TK856 8 pagina's. Remote sensing temperature recorder

Pagina afdrukken

1. 1. 1. 1. To set the alarm, make sure unit is on and press and hold the Alarm

rapidly for about five seconds, then the LED will turn solid green. Release the Alarm

LED will turn solid red. At this point the display will show "On" or "Off".

Pressing either the Adjust

Adjust

Adjust- - - - Up

switch, will toggle the alarm on or off.

2. 2. 2. 2. Pressing PEN

PEN

PEN HOME

HOME will scroll to the next alarm options.

HOME

Pen 1 alarm minimum

Pen 1 alarm maximum

If KT856 two pen model, the additional options are:

Pen 2 alarm minimum

Pen 2 alarm maximum

3. 3. 3. 3. In order to set pen(s) alarm minimums and maximums, pressing Adjust

value, and pressing Adjust

button is held down.

Repetitively pressing the Pen

is pressed to exit from alarm adjust. Each press of the Pe

settings. The unit will take one minute to exit Alarm Set Mode once the Alarm

4. 4. 4. 4. If the alarm is triggered, the LED will show as solid red and the alarm will sound. Press the Alarm

button to silence the audible alarm.

Alarm Relays

Alarm

Relays

Alarm

Relays

The SPST 24V 500mA relay contacts are Normally open and will close on alarm conditions when the

alarms are enabled. Relay contacts are always functional when the alarm is enabled. The relay will close

only during minimum and maximum alarm conditions. The KT856 has 2 sets of relay contacts which

operate independently. Relays will not operate under battery only power conditions.

PENS

The blue pen has a longer pen arm and records channel 2 temperature (depending on your dip switch

selection, see pg. 4). The red pen has a shorter arm and records channel 1 temperature. The pens are

offset to allow the red pen to glide under the blue pen. The blue pen indicates the correct time and the

red pen precedes it by 3/16 of an inch.

Dickson KT8P Manual V6 52418

Up or Adjust

Adjust

Adjust- - - - Down

Adjust

Down

Down buttons, located on the back of the unit next to the dip

Adjust- - - - Dow

Down n n n will decrease the alarm value. There is acceleration if the Adjust

Adjust

Dow

Pen Home

Home button will scroll through the five options until the A A A A larm

Pen

Home

Alarm button. The LED will blink red

Alarm

Adjust

Adjust- - - - Up

Up will increase the alarm

Pen n n n Home

Home or Alarm

Alarm button will store the new

Home

Alarm

Alarm button is pressed.

Alarm button and the

Alarm

Adjust- - - - Up

Adjust

larm button

larm

Alarm