EPCO TIGERcub 175 HID Beknopte handleiding - Pagina 2

Blader online of download pdf Beknopte handleiding voor {categorie_naam} EPCO TIGERcub 175 HID. EPCO TIGERcub 175 HID 2 pagina's.

Lamp Installation

1. Install the supplied lamp and make sure that the extended center contact on

the bottom of the lamp is fully "seated" into the fixture's lamp socket to

complete the circuit. Note: If the lamp is not fully seated into the fixture's

lamp socket, the lamp will not light.

Lamp Safety Guard Installation

1. After you have installed the lamp into the fixture you can now install the Lamp

Guard to protect the lamp from damage.

2. Place the Lamp Guard on a flat surface. Locate the three (3) contact points on the

Lamp Guard - the two (2) closed-loop "round" tangs and the one (1) round hook. They should be facing upward. Connect the

round hook onto the bottom section of the Safety Cage as shown in Figure 3. The Lamp Guard should swing downward but

still remain attached to the Safety Cage by the round hook.

3. Swing the Lamp Guard upward so that one of the round tangs fits onto the bottom section of the Safety Cage. Then apply

upward pressure on the second tang until it also fits onto the bottom section on the Safety Cage. Rotate the Lamp Guard either

left or right to make sure it is firmly attached.

• Ultraviolet, and infrared radiation is emitted from metal halide lamps.

• Possible skin or eye irritation can result from exposures exceeding 15 minutes.

• Do not stare at exposed lamp in operation.

• Do not remove the lamp from light fixture until it has cooled.

• Never handle the lamp when it is operating!

CAUTION

E n g i n e e red Prod u cts Co m p a ny

5401 Smetana Dri ve • Mi n n e to n ka, MN 55343

(952) 767-8780 / (800) 336-1976 • Fax (952) 767-8786 / (800) 336-2801

Visit our Web Site at engp ro d u ct s. co m

Safety Cage

Lamp Guard

Round

Tangs (2)

Figure 3. Installing, opening and closing the

Lamp Safety Guard.

E02-053-003 B1 (8/09 - AGIII)