DieHard Portable Power 950 Gebruikershandleiding - Pagina 9
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DieHard Portable Power 950. DieHard Portable Power 950 13 pagina's. 12v dc power source and jump starter
Ook voor DieHard Portable Power 950: Gebruikershandleiding (9 pagina's), Gebruikershandleiding (9 pagina's), Gebruikershandleiding (9 pagina's), Gebruikershandleiding (7 pagina's)
Pagina afdrukken
7.
CHARgINg THE INTERNAL BATTERY Of THE JUMP STARTER
IMPORTANT: CHARgE IMMEDIATELY AfTER PURCHASE, AfTER EACH
USE AND EvERY 30 DAYS TO KEEP THE JUMP STARTER INTERNAL
BATTERY fULLY CHARgED.
7.1
To check the internal battery's charge status, toggle the Light/display switch
to the dISPLAY position. The digital display will show the battery's percent of
charge. Charge the internal battery if the display shows it is under 100%
NOTE: Internal battery's percent of charge is most accurate when the jump
starter has been disconnected from all devices and charging sources for a
few hours.
7.2
Charging the Internal Battery using the Included Wall Charger.
1.
To charge, plug the included wall charger into the charger plug on the back
of the jump starter.
2.
Plug the wall charger into a 120v AC electrical wall outlet.
3.
While the jump starter is charging, the battery's percent of charge will be
displayed. When the internal battery is fully charged, the display will show
100. Complete charging may take up to 72 hours. The jump starter is then
ready to use.
4.
The charger will automatically go into maintain mode and maintain the
battery at full charge without damaging it.
5.
Charge the jump starter as soon as possible after use.
internal battery.
You may also charge the internal battery while driving, using the male-to-male
charger cable (p/n 94500109 – not included). Insert one end of the accessory
cable into the 12v dC power outlet and the other end into the vehicle's
accessory outlet (lighter socket). Completely disconnect the charger cable
when the engine is not running.
maintain mode and the battery can be overcharged. Monitor the progress of
the battery and when it reaches a full (100%) charge, disconnect the charger.
do not leave the battery unattended or it could explode causing property
damage or personal injury.
8.
OPERATINg INSTRUCTIONS
8.1
Digital Display functions
To check the jump starter internal battery's status, push the display Button.
The display will show the percent of charge of the internal battery.
When connected to the vehicle with the Jump Start On/Off switch in the OFF
position, the display shows the vehicle's battery voltage. When connected
and in the ON position, the display shows the equalized voltage between the
vehicle's battery and internal battery.
8.2
Jump Starting a vehicle Engine
internal battery.
1.
Turn the vehicle's ignition OFF before making cable connections.
2.
Connect the jump starter to the battery following the precautions listed in
section 3.
do not use the jump starter while charging the
Using this method to charge the battery overrides the
do not use the jump starter while charging the
•
6
•