Axkid Rekid Gebruiksaanwijzing - Pagina 12

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Axkid Rekid. Axkid Rekid 16 pagina's.

Adjustment Lever (2) to select one of the three

reclining positions. Always choose the most up-

right angle as possible, but there should be enough

recline to ensure your child's head does not fall

forward when sleeping. The rule of thumb is that

the older the child grows, the more upright the

seat can be installed. Bear in mind that once the

installation of the Rekid is complete, it will be

somewhat more reclined as it sinks into the ve-

hicle's seat from tightening seat belts and tether

straps.

Fastening the vehicle seat belt

Open the lock-offs (3) on both sides of the

Rekid child restraint. Fully lengthen the seat belt

until the lap section of the belt is at least 70-80

cm (27-32 inches) long. Feed the seat belt be-

tween the seat cover and seat body through the

seat belt slot (4) until the belt comes out through

the opening on the other side. If you prefer, you

can instead feed the seat belt over the top of the

seat belt cover. Engage into the vehicle's seat belt

buckle. Pull seat belt until all slack is removed

along the seat belt route. Then secure both the

lap and shoulder belt in the lock-off closest to the

vehicle's seat belt buckle. In the lock-off on the

opposite side, only the lap belt should be secured.

Attaching the lower tether straps

Some vehicles may already be fitted with an-

chorage points at the base of the front seat rails,

or, if installing in the front passenger seat, in front

of that seat. If your vehicle does not have these

anchor points, the supplied lower tether straps

must be used to, see pages 7-8 for example. For

installation in the back seat, feed the buckle end

of the tether strap through either the rear of the

front seat rails, or the hinge of the front seat. The

Continued on next page

Lower tether straps