Axminster MCB100A Gebruikershandleiding - Pagina 13

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Axminster MCB100A. Axminster MCB100A 20 pagina's. 4" metal cutting bandsaw

8.Adjustment

An unbounded handle is mounted on the unit

for freely changing direction by lifting it up

and turning a little bit. It's designed for your

convenience to adjust blade guide easily and

quickly at any time, and under any situation.

Adjustment of this blade guide is in

accordance with the sizes of work pieces.

The only one located at the left of the saw

head can be adjusted and the other is fixed.

1. If the work is big, loosen the handle (A) in

Fig.7. move the guide toward the work

about one inch then tighten the handle.

2. When cutting a small work, move the

guide toward the work as close as it can

be. Both cuttings will present you

satisfactory jobs.

WARNING

Do not make any adjustments, or load,

unload work from vise when machine is

running!

The machine has been adjusted and

power-tested with several test cuts before

leaving the factory to insure proper cutting. If

there is any poor cuts occurred, correct it as

follows.

Fig.7

1. Bad cuts due to blade worn, replace a

new blade.

2. The saw uses fixed ball bearings. For

keeping proper cutting, the best way is to

replace them every three or six months

depending on the frequency of service.

3. Poor cuts can be made because the fixed

nut (A) is getting loose. Then tighten it

properly.