Axminster AWVSWL1200D Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Axminster AWVSWL1200D. Axminster AWVSWL1200D 19 pagina's. Woodturning lathe

WOODLATHE MANUAL

according to the instructions.

2. OBTAIN ADVICE from your supervisor, instructor, or another qualified person if

you are not familiar with the operation of this machine.

3. FOLLOW ALL WIRING CODES and recommended electrical connections.

4. ROUGH CUT THE WORKPIECE as close as possible to the finished shape before

installing it on the faceplate.

5. EXAMINE THE WORKPIECE FOR FLAWS and test glue joints before mounting

the workpiece on machine. DO NOT mount a split workpiece or one containing a

knot.

6. SECURELY FASTEN THE WORKPIECE to the faceplate prior to faceplate turning.

Use the appropriate size faceplate to properly support the workpiece. Do not let the

screw fasteners interfere with the turning tool at the finished dimension of the

workpiece.

7. NEVER DRIVE THE WORKPIECE into the drive center while the drive center is in

the headstock. Set the drive center into the workpiece with a soft mallet prior to

installing it on the headstock.

8. SNUG THE TAILSTOCK CENTER against the workpiece and lock it. Lubricate the

tailstock center if it is not a ball bearing center.

9. PROPERLY ADJUST THE TOOL REST HEIGHT.

10. ADJUST THE TOOL REST so it is as close to the workpiece as possible.

11. TIGHTEN ALL CLAMP LOCKING HANDLES before operating.

12. ROTATE THE WORKPIECE BY HAND to check clearance before turning the

machine "ON".

13. CLEAR THE LATHE BED OF ALL OBJECTS (tools, scraps of wood, etc.) before

turning the machine "ON". FAILURE TO FOLLOW THESE RULES MAY RESULT IN

SERIOUS INJURY.

14. EXAMINE THE SET-UP CAREFULLY before turning the machine "ON".

15. STAND CLEAR, AND KEEP ALL OBSERVERS AND PASSERSBY clear of

rotating path of workpiece to avoid injury from flying debris.

16. USE THE LOWEST SPEED when starting a new workpiece. NEVER EXCEED

recommended speeds.

17. NEVER ADJUST THE TOOL REST while the workpiece is turning.

18. NEVER LOOSEN THE TAILSTOCK SPINDLE or the tailstock while workpiece is

turning.

19. MOVE THE CUTTING TOOL INTO THE WORK-PIECE SLOWLY, and cut small

amounts when roughing.

20. REMOVE THE TOOL REST before sanding or polishing.

21. NEVER PERFORM LAYOUT, assembly, or set-up work on the table/work area

when the machine is running.

22. TURN THE MACHINE "OFF" AND DISCONNECT THE MACHINE from the

power source before installing or removing accessories, before adjusting or changing

set-ups, or when making repairs.

23. TURN THE MACHINE "OFF", disconnect the machine from the power source,

and clean the table/work area before leaving the machine. LOCK THE SWITCH IN