Axminster Router Elevator Gebruikershandleiding - Pagina 13

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Axminster Router Elevator. Axminster Router Elevator 16 pagina's.

Fitting the Accessory Digital Readout Scale...

Fig 7a

Clamping plate

Fig 8

If the DRO is masked/shielded/awkwardly sighted when the assembly is mounted in your

installation, you may wish to consider the addition of the Single Axis Remote Reader

(210068) whereby you can place the relayed digital readout where it is most convenient.

The router elevator requires minimum maintenance, but you are advised to observe the

following points:-.

1. Keep the elevator clean. Ensure that dust/chips etc., are cleaned away at the end of a

work session.

2. Do not allow a build up of dust/chips etc., between the machine table and the rise and

fall platform, or under the machine, where it may foul the chain drive.

3. If the winding action becomes 'lumpy' check that there is no debris caught in the chain,

or compressed onto a sprocket.

4. Check the chain tension. If the chain has become 'slack' or loosened, re-tension by

adjusting the idler sprocket. Do not over tension, the chain needs to be firm, with a small

side to side movement (best checked on a 'long' side): it does not need to be rigid.

5. Remember! A chain is a machine as well, give it a light lube.

Mounting plate

Fitting the

clamping plate

Attachment

bracket

Screws

Fig 7

Data output port to

connect the Single

Axis Remote Reader

Fig 9

Maintenance...