Axminster BS100 Handmatig - Pagina 11
Blader online of download pdf Handmatig voor {categorie_naam} Axminster BS100. Axminster BS100 17 pagina's. Belt sander
Pagina afdrukkenIf it is necessary to transport the machine after using, please protect cables
firstly and discharge the scrap iron.
Remove the protective coating from all unpainted surfaces. After cleaning, cover the
unpainted surfaces with a good quality household floor paste wax.
5 Installation of machines
5.1 Preparation before installation
5.1.1 Requirement of operating site
The machine is designed for operation on the following site:
The height above sea level doesn't exceed 1000m.
-
The temperature range of air shall be 5℃～40℃.
-
The relative humidity doesn't exceed 50% at a maximum temperature of +40 ℃.
-
Higher relative humidity may be permitted at lower temperature (e.g.90% at 20℃).
Lighting within the workzone shall be provided with a minimum of 500lux.
-
Clean environment, good ventilation and enough space shall be kept to operate and
-
maintain the machine conveniently.
5.1.2 Requirements of electrical power
Note: The end user should provide over-voltage protection device on the
incoming power supply when finishing installation on the spot!
Voltage
The input power supply of the machine is 1/PE, AC220V for JSG75A and
JSG100A.
The input power supply of the machine is 3/PE, AC380V for other models.
Frequency
0.99～1.01 times of rated frequency ( 50 Hz , continuous working)
0.98～1.02 times of rated frequency(50Hz, short period working)
Harmonics
The sum of 2nd-5th distorted harmonic must not exceed 10% of RMS of voltage.
An additional 2% of RMS of line voltage is allowed to for the sum of 6th-30th
harmonic.
Unbalanced voltage
Neither negative nor zero sequence component is allowed to exceed 2% of the
positive sequence component.
Short-circuited protection and incoming cable
The machine should have short-circuited protection device at the power supply end by
the end-user. The rated current is recommended as 10A, and the diameter of the
incoming
Green-and-Yellow).
5.2 Installation
5.2.1 Minimum installation space for the machine
line
must
not
be
less
than
3×1.5mm
11 / 16
2
2
(Black)
+1.5mm
(PE,