Axminster ZQJ4125K Handmatig - Pagina 15

Blader online of download pdf Handmatig voor {categorie_naam} Axminster ZQJ4125K. Axminster ZQJ4125K 18 pagina's.

Pagina afdrukken

2. Open the chuck wide enough to accept a new bit.

3. Install the bit so the chuck jaws will grab as much of the bit shank as it can. Do not

allow the chuck to grab the fluted body of the drill bit. Make sure small drill bits do not

get trapped between the edges of two jaws.

4. Tighten the chuck with the chuck key using any of the three key end locations.

5. Remove the chuck key and reconnect power source.

6. Reverse steps to remove drill bit.

6: MAINTENANCE

General

Regular periodic maintenance on your drill press will ensure its optimum performance.

Make a habit of inspecting your machine each time you use it. Check for the following

conditions and repair or replace when necessary:

1. Loose mounting bolts.

2. Worn switch.

3. Worn or damaged cords and plugs.

4. Damaged V-belt.

5. Any other condition that could hamper the safe operation of this machine.

Tables

The nonpainted surfaces on the drill pressshould be protected against rust and pitting.

Wiping the machine clean after every use ensures that wood dust will not trap moisture

against bare metal surfaces.

Some woodworkers recommend using automotive paste wax on exposed steel and cast

iron surfaces. The wax provides a layer of protection, as well as reducing friction between

lumber and the table, making cuts faster and smoother. Avoid waxes that contain silicone

or other synthetic ingredients. These materials can find their way into lumber that is being

worked, and can make staining and finishing difficult. If you use paste wax, make sure that

it is 100% Carnauba wax.

Lubrication

Inspect regularly for tension and wear. Check pulleys to ensure that they are properly

aligned. See pulley/V-belt sections for proper tension and pulley alignment procedures.

V-Belt

Since all bearings are shielded and permanently lubricated, simply leave them alone until

they need to be replaced. Do not lubricate them.

7: TECHICAL DATA

Model

Spindle Taper

Chuck (mm)

Spindle Travel

Swing(mm)

Speeds

Height

Motor

N.W./G.W.

We reserve the right of the amendment addition and deletion of the

specifications, explanatory wording, etc. printed in this manual

PDF 文件使用 "pdfFactory Pro" 试用版本创建

DRILL PRESS MANUAL

Floor

ZQJ4125K

MT3

3-16mm

80mm

432mm/17"

12s

990mm

See Nameplate

108/117kgs

www.fineprint.cn

ZQJ4132K

MT4

3-16mm

120mm

508mm/20"

12s (

1000mm

See Nameplate

143/153kgs