Axminster MD150Q Gebruikershandleiding - Pagina 15
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Axminster MD150Q. Axminster MD150Q 16 pagina's. 150/200mm wetstone grinder
Ook voor Axminster MD150Q: Gebruikershandleiding (20 pagina's)
Nut
Fig 15
Now is a good time to clean the water trough thoroughly, and check for, and correct any
signs of erosion/oxidation on the gearbox components. Fit the new stone and re-assemble
in reverse order. Take care not to over-tighten the securing screws, as damage could result
to the fixing lugs of the water trough. Replace the bung/leg and refill the trough with clean
water.
!
If the grindstones wear unevenly, producing crests, dips or rounded edges, they
should be dressed out using a suitable wheel dressing tool. (A selection of stone dressing
tools are available in the Axminster catalogue.)
Switch the grinder on and allow it to run for at least one minute. Rest the dressing tool on
the tool rest and advance it to the stone until it touches the maximum diameter; gently move
the dresser back and forth across the face of the stone until all irregularities have been
removed and the edges of the stone are nice and sharp.
Changing the Wet Grinding Wheel...
Plate flange
Fig 16
This is not a procedure that can be
rushed, it must be carried out slowly
and steadily.
FREEPHONE
Grindstone
Dressing a Stone...
!
PLEASE NOTE
Dressing the wheel using a
Wheel Dressing Stick or
Devil Stone
Part no. 410074
0800 371822
Fig 17
W
A X M I N S T E R
W H I T E
15