Axminster Trade 101701 Originele handleiding - Pagina 10

Blader online of download pdf Originele handleiding voor {categorie_naam} Axminster Trade 101701. Axminster Trade 101701 18 pagina's.

Pagina afdrukken

Basic Operations

Removing

exposes more of the sanding belt! Replace the

belt guards immediately after completing any

sanding that requires its removal! Failure to

comply may cause serious injury!

Horizontal Sanding

For horizontal sanding, the platen is locked in the

horizontal position as shown (F) and the removable

fence (D) is secured to the table (E) as follows.

Referring to Figure 16:

1. Place 5/16 flat washers (not shown) and guide

blocks (B) on two 12mm lock knobs (A) – Note:

the 12mm refers to the threaded shaft length.

2. Insert the guide blocks (B) into the miter slot

table (E) as shown.

3. Place the removable fence (D) on the table

and secure by tightening the lock knobs

(G, Fig. 16 and Figure 17).

The backstop (H, Fig. 17) can also be used by

swiveling the drum guard & dust port (J, Fig. 17)

out of the way and placing the backstop pin in the

positioning hole and securing in place with the lock

knob (K, Fig. 17) and 5/16" flat washer. Note: This

is better shown in Figure 18. The drum guard &

dust port (J, Fig. 17) can then be returned to the

position shown.

Vertical Sanding

Referring to Figure 18:

For vertical sanding, the platen (G) is locked in the

vertical position as shown and the backstop (H)

and/or the miter gauge (B) may be used.

Miter Gauge

1. Slide the guide bar (D) of the miter gauge (A)

into the miter slot (C) on the table.

2. Set the miter angle; then secure the miter by

tightening the lock handle (B).

Backstop

Place the backstop pin in the positioning hole and

secure in place with the lock knob (E) and 5/16"

flat washer (F).

the

belt

guard

Figure 16

Figure 17

Figure 18