Accuphase AD-2810 Gebruiksaanwijzing - Pagina 2

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Accuphase AD-2810. Accuphase AD-2810 2 pagina's. Phono equalizer unit

Pagina afdrukken

Thank you for purchasing the Phono Equalizer Unit AD-2810.

This unit is designed for installation in the preamplifier models listed below, to provide

analog disc reproduction capability. After installation, all functions are operated with

the controls on the front panel of the preamplifier. For details about use, please refer to

the instruction manual of the preamplifier in which the unit is installed.

＊Supportedmodels : C-2810, C-2800, C-2410, C-2400, C-290, C-290V

●

Set the power switch of the preamplifier to OFF.

●

Remove the sub panel of the expansion slot on

the rear panel. Use the supplied hex wrench to

remove the four screws by turning them coun-

terclockwise (see Fig. 1).

The removed sub panel is not used.

Expansion

slot

Guide rails

Sub panel

CAUTION

Be sure to set the power switch of the preamplifier to OFF before inserting or

●

removing the AD-2810. Otherwise damage may occur.

Do not touch the component side, solder side, or connector of the AD-2810.

●

Otherwise static discharge may cause damage, and contact problems may occur.

Make sure that all four screws of the are securely fastened. Otherwise a floating

●

ground condition may occur, which can lead to damage.

2-14-10, SHIN-ISHIKAWA, AOBA-KU, YOKOHAMA 225-8508, JAPAN

J071.5X

PHONO EQUALIZER UNIT

AD-2810

Installation

Hex wrench

Fig. 1

ACCUPHASE LABORATORY, INC.

Instruction Manual

●

Slide the AD-2810 into the preamplifier along the

two guide rails on both sides (see Fig. 2). When

you feel a certain resistance, give the AD-2810 a

slight push until the connector is fully plugged

in. When the AD-2810 is flush with the rear panel,

it is inserted correctly.

●

Use the four screws to fasten the AD-2810 by

turning the screws clockwise.

Phono Equalizer Unit

AD-2810

Fig. 2

820-3248-00(K1) Printed in Japan