AccuPower IQ328+ Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AccuPower IQ328+. AccuPower IQ328+ 7 pagina's. Li-lon nimh nicd

Pagina afdrukken

The measured capacities can be, as well as in the "Charge Test", retrieved by pressing the

channel button. If a high charging current is chosen, it can happen in some cases that the

full charging capacity is not reached (this depends on the quality and condition of the

battery).

A lower charging current is able to put more energy into the battery but therefore the

procedure lasts longer. The procedure to see the chosen currents and the measured

capacities is the same as for "Charge Test". This is the best way to measure the current

state of health of the battery (still available capacity of the cell).

At "Charge Test" and "Discharge Test" the discharging current will be selected

automatically to 500 mAh. The table below shows the selectable charging current values

followed by its discharging current.

Selected charging current

Following discharge current

Charge:

If you like to charge one or more batteries, it distinguishes between same type or different

cells:

• Batteries of the same type

Firstly, insert the batteries into the charger. The charger registers the inserted

batteries and starts to identify the battery chemistry. By default, the charge process

and a charging current of 500 mA gets selected automatically. The same conditions

will be used for all inserted batteries and can be changed through pressing the

mode button. If you want to change the settings, you can do that as long as the font

is flashing. The desired program can be selected by pressing the MODE button as

well as the charging current can be selected with the CURRENT button. After the

font stops flashing, the program is activated and starts to charge/discharge the

batteries.

TIP: Disconnect the charger from the power, insert the batteries in the channels,

connect the charger to the power again and select the wanted conditions through

the LC Display flashes, as mentioned above.

• Individual setting:

If you want to charge different batteries with individual settings, it is recommended

to insert the batteries separately one by one. Only when all the settings via the

appropriate keys were selected for the first battery and the font on the LC display

stops flashing, the battery is taken from the charger. Now the next battery can be

inserted and selected as described before. If you like to change the selected

program, press the mode button for some seconds till the font starts to flash on the

LC display and then it is possible to change the function through pressing the mode

button again. If you like to change the current you can change it through pressing

the CURRENT button, that's possible as long as the function flashes on the LC

display, after some seconds the charger accepts the now selected information and

stops flashing.

If the charger started the selected program, it can only be interrupted through removing the

cells from the slots or pressing the mode button for some seconds. Short pressing of the

mode button cannot interrupt the running program. This is a protection against

unintentional cancel the program.

User Manual

300 mA

500 mA

300 mA

5/7

700 mA

1000 mA

500 mA

Update version-V2