ARC AT501 Gebruiksaanwijzing - Pagina 5
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} ARC AT501. ARC AT501 7 pagina's. 2.4ghz 4 channel radio remote control transmitter, digital proportional radio control system
Pagina afdrukken
their centered position during installation. The
servo
connectors
improper connection, but do pay close attention
when connecting them to the receiver. The
black wire goes toward the outside edge of the
The receiver must be bound to the transmitter before it will operate. Binding is the process of teaching
the receiver the specific code of the transmitter so it will connect to that specific transmitter. Once
bound, the receiver will only connect to the transmitter when the previously bound model memory is
selected. If another model memory is selected, the receiver will not connect. This feature prevents
flying a model using the wrong model memory.
1. Switch on the transmitter, ensuring that the
throttle control stick at its lowest position.
2. Connect the receiver battery to the receiver
and wait until the Power Indicator LED on the
receiver glows solid green.
3. Press and hold the Binding Switch on the
receiver for approximately 5 seconds until the
Binding Indicator LED on the receiver goes
It is very important to check the transmitter will operate the model satisfactorily at maximum range.
1. In order to do this, place the model on the
ground and walk away from it whilst operation
the swashplate controls. Check that the servo
in the model operate without interference up to
a distance of 33m.
The operating direction, neutral position and steering angle of each servo are adjusted.
Caution: The basic linkage and adjustments of the fuselage conform to the fuselage design drawing.
Be sure that center of gravity is at the prescribed position.
Before making and adjustments, set all the servo reverser switches on the front of the transmitter to
the lower (NOR) position (Switch the switches with a small screwdriver).
Turn on the transmitter and receiver power switches and make the following adjustments.
1. Servo Reverser Switch (Option Function):
are
keyed
to
prevent
RANG & BATTERY TEST
ADJUSTMENTS
receiver case. Mount the switch harness to the
side of the fuselage away from the engine
exhaust (refer to your model's instruction
manual). Connect the red plug to the receptacle
on the receiver marked B for battery.
BINDING
solid green, indicating the binding finished.
2. Check that the transmitter battery status LED
is showing a bright red. Do not fly if the LED
begins to flash, as the batteries need to be
replaced or recharged. .
Check the direction of each servo. If a servo
Power Indicator
Binding Indicator
Binding Switch