Cino FuzzyScan FM400 Programming Snelstarthandleiding - Pagina 5

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cino FuzzyScan FM400 Programming. Cino FuzzyScan FM400 Programming 17 pagina's. Fixed mount scanner

Pagina afdrukken

Use the Test Mode

The FuzzyScan FM400 provides an useful test mode which is helpful for you

to quickly identify the best mounting position. Please refer to the descriptions

listed below for details.

Test Button

Under normal operation, the Test Button of FM400 just acts as a normal

trigger switch of hand-held scanner. You can press the Test Button to scan

the corresponding barcode commands to configure your scanner with ease.

Please note that if you press the Test Button over 5 seconds, the FM400

will enter the test mode automatically.

Test Mode

Once determine your desired location to install the scanner, you may use the

test mode to optimize the mounting position with ease. Please follow below

procedures to use the test mode.

Hold the Test Button over 5 seconds until the status indicator gives one

green blink, then release the button to activate test mode. The scanner

will give 2 short beeps and the power indicator will flash blue blink per 1

second. The scanner will turn on the light source to scan barcodes

continuously before exit the test mode.

Keep scanner to read the same test barcode. The scanner will count the

Good Read numbers, then output the information of reading rate and

refresh LED indications every 100 scans. The format of output message

is listed below.

< Readout data >

At the same time, both Status and OK/NG indicators will provide the

visible reading rate information as well. You may refer to the table listed

below for details.

Reading Rate

100%

80 to 99%

50 to 79%

20 to 49%

0 to 19%

If the reading rate is not good enough, please adjust the reading angle

and distance to get the optimum readability. If you would like to exit the

test mode, please press the Test Button once again.

1. If the scanner is unable to read any barcode during preset scan input

time-out (default is 900ms), the scanner will count it as a NG reading.

2. Under test mode, the OK/NG output signals will not be performed.

< Reading rate (0 to 100) >

Status Indicator

Steady Green

Steady Red

Steady Green

Steady Orange

Steady Red

OK/NG Indicator

Steady Green

Steady Red

Steady Orange

Steady Red