Arc-Zone DGP-2-V2 Bedieningshandleiding - Pagina 5

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Arc-Zone DGP-2-V2. Arc-Zone DGP-2-V2 13 pagina's.

safety (continued)

• Make sure that the grinder is off before plugging it in.

• Do not apply extreme force on the tungsten while grinding. This may cause your grinder to jam or cause pre-

mature grinding wheel wear.

• Never leave the grinder unattended. Turn the grinder off first and do not leave it until it comes to a complete stop.

• Keep hands away from moving parts.

• Know your grinder; learn its operation, applications, and specific limitations.

• Always unplug grinder prior to inspection.

• Read this manual thoroughly for specific adjustments and operating procedures.

6 . OPERATOR INFORMATION

Operator should know How to Use the Grinder

• Only use the grinder for its intended purpose. Do not use it for a job it was not designed for. Grinding parts

other than tungsten will severely decrease wheel and equipment life.

• Unplug the grinder when changing accessories, such as collets, wheel, or other replacement parts.

• Avoid accidental start-up. Make sure that the grinder is in the off position before plugging it in.

• Do not force the grinder. It will work most efficiently at the rate for which it was designed. Consult the "

Recommended Minimum Cutting and Grinding Time for New Electrodes" sticker on the grinder to determine

optimum rate of speed.

• Use recommended accessories. Use of improper accessories may cause risk of injury of persons or accelerated

wear on the grinder.

• Handle the tungsten and grinder correctly. Consult grinder operation procedures in this manual and handle

tungsten with pin vise whenever possible to protect hands from possible injury.

• Feed tungsten into grinding wheel against the direction of rotation of the wheel.

• Turn the wheel off if it jams. A wheel jams when it digs too deeply into the tungsten (the motor force keeps it

stuck in the tungsten).

• Never leave the grinder unattended. Turn the grinder off first and do not leave until it comes to a complete

stop.

• Never stand or lean on the grinder. Serious injury could occur if the grinder is tipped or if the cutting tool is

unintentionally contacted.

• Keep hands away from moving parts and cutting surfaces.

Operator should Be prepared for the Job:

• Wear proper apparel. Do not wear loose clothing gloves, neckties, bracelets, or other jewelry which may get

caught in moving parts of the machine.

• Wear protective hair covering to contain long hair.

• Wear safety shoes with non-slip soles.

• Wear safety glasses. Prescription glasses have only impact resistant lenses.

• Wear face mask or dust mask.

• Be alert and think clearly. Never operate power tools when tired, intoxicated, or when taking medications that

cause drowsiness.

Document: DGP-2 & DGP-2-V2 Tungsten Grinder Product User Manual | Released: 5/13, Rev. A

Arc-Zone.com, Inc.

Page 5

2091 Las Palmas Drive, Ste. F

Carlsbad, CA 92011 - Tel. 1.760.931.1500

5 / 13