AXTON A200 Installatie- en bedieningshandleiding - Pagina 3
Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} AXTON A200. AXTON A200 17 pagina's. 1-/2-/4-/5-channel power amplifiers
Pagina afdrukken1. CONNECTIONS + CONTROLS A200 - PAGE I
1
SIGNAL INPUTS R / L
Low-level stereo RCA signal or high-level speaker signal input terminal for connection
to head-unit.
2
AUTO-TURN-ON MODE
Slide switch to select the auto-turn-on function: REM by remote wire, VOX to switch on
by music signal or DC by DC offset signal of the head units integrated amplifier.
3
INPUT MODE SELECTION
Switch to select the proper input sensitivity range: RCA signal input = Low. Speaker
signal input = Hi.
4
INPUT GAIN CONTROL
Input gain potentiometer for the subwoofer output channel, to match the output voltage
of the head unit to the amplifier's input.
5
OPERATION MODE SWITCH
Slide switch to select the operation mode of the X-over of the amplifier: Highpass
[HPF], Lowpass [LPF] or full signal
6
X-OVER FREQUENCY CONTROL
Control potentiometer to adjust the highpass or lowpass filtering frequency of the
amplifier.
7
POWER LED
LED to show the operating status of the amplifier by blue/red illumination. Blue is
normal working mode, red is protect mode of amplifier.
8
SPEAKER OUTPUT TERMINAL
Output terminal to connect the speakers to the amplifier in either stereo or bridged
mode.
9
"+12 V" POWER INPUT TERMINAL
Terminal to connect the amplifier to the positive +12V pole of the car battery.
10 "REM" INPUT TERMINAL
Terminal to connect the amplifier to the automatic (remote) turn-on / turn-off lead of the
head unit. By using the REM terminal, you need to switch the Auto-turn-On mode
to the "REM" position.
11 "GND" POWER INPUT TERMINAL
Terminal to connect the amplifier to the chassis ground or negative pole of the car
battery.
– 4 –
1. CONNECTIONS + CONTROLS A200 - PAGE II
1
2
2
3
4
5
105.0 mm
8
9
bl bm
– 5 –
6 7